V-tech SWITCH&GO HATCH & ROAAAR EGG PTERODACTYL... User manual

Instruction Manual
HATCH & ROAAAR EGGHATCH & ROAAAR EGG
PTERODACTYL CHOPPERPTERODACTYL CHOPPER
®

2
INTRODUCTION
Thank you for purchasing Switch & Go®Hatch & Roaaar Egg
Pterodactyl Chopper.
Assemble this agile Pterodactyl, then transform it in a few simple
steps into a super cool helicopter. Ready to smash and crash? Here
we go!
Talk Button
Off / Dino Mode /
Vehicle Mode Switch

3
INCLUDED IN THE PACKAGE
• Switch & Go®Hatch & Roaaar Egg Pterodactyl Chopper
• 15 Pieces for Assembly
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of
this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’utilisation car il comporte
des informations importantes.
Unlock the Packaging Locks:
Turn the packaging lock
counterclockwise several times.
Pull out the packaging lock
and discard.

4
GETTING STARTED
Exit Try-Me Mode:
The product is in try-me mode in the packaging. To exit try-me
mode, just slide the “Off/Dino Mode/Vehicle Mode” Switch from
Vehicle mode to Dino mode.
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit. Use a screwdriver
to loosen the screw, and then open the
battery cover.
3. Remove the old battery by pulling up on
one end of the battery.
4. Install 1 new AAA battery following the
diagram inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries
are recommended.)
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from the toy before
charging.
• Rechargeable batteries are only to be charged under
adult supervision.
• Do not charge non-rechargeable batteries.

6
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec
des usagés.
• Ne pas mélanger différents types de piles : alcalines,
zinc-carbone et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de
non-utilisation prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.

7
ASSEMBLY INSTRUCTIONS
1. Identify the following pieces for assembly:
01 02
03
04 05 06 07
07
08 09 10
11 12 13 14

8
2. Separately install the A, B, C, D, E, F and G parts as shown in the
illustrations.
A
B
C
01
02
03
04
07
07
14
13
08

9
D
A
D
E
09
05
10
12
06
11

10
F
G
B
E
C

11
TRANSFORMATION
1. Begin in Dino mode.
3. Flip the Dino’s feet up toward
the Dino’s head.
2. Flip the long section of wings
forward toward the Dino’s head.
4. Fold the small section of wings
down until they are close to the
body.

12
Note: To switch from Vehicle mode to Dino mode, follow the above
steps in reverse order.
5. Extend the rotor blades so that
they form a straight line.
7. The Dino is now in Vehicle mode.
Flip the Off/Dino mode/Vehicle mode
Switch to play Vehicle responses.
6. Flip the rotor 90 degrees so
that it is parallel to the dino’s
body.

13
PRODUCT FEATURES
1. OFF / DINO MODE /
VEHICLE MODE SWITCH
Slide the Off / Dino Mode / Vehicle
Mode Switch to turn the unit ON
and choose Dino mode( ) or
Vehicle mode( ) to play. Slide
the Off / Dino Mode / Vehicle Mode
Switch to the Off position to turn
the unit OFF.
2. Talk Button
Press the Talk Button to hear fun
phrases and cool dinosaur sounds
in Dino mode, or hear fun phrases
and great vehicle sounds in Vehicle
mode.
3. AUTOMATIC SHUT-OFF
To preserve battery life, Switch & Go®Hatch & Roaaar Egg
Pterodactyl Chopper will automatically turn off after a few
seconds. Switch & Go®Hatch & Roaaar Egg Pterodactyl
Chopper can be woken up again by pressing the Talk Button, or
by switching between Dino and Vehicle modes.
NOTE: If the unit powers down or if the light flashes 3 times during
play, please install a new set of batteries.

14
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, replace with a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S.,1-877-352-8697
in Canada, or visit our website vtechkids.com and fill out our
Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort
to ensure the accuracy of the information, which forms the value
of our products. However, errors sometimes can occur. It is
important for you to know that we stand behind our products
and encourage you to contact us with any problems and/or
suggestions you might have. A service representative will be
happy to help you.

15
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changesormodicationsnotexpresslyapprovedbytheparty
responsible for compliance could void the user’s authority to operate
the equipment.

16
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5594
Product Name: Switch & Go®Hatch & Roaaar Egg
Pterodactyl Chopper
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES.OPERATIONISSUBJECT TOTHE FOLLOWINGTWO
CONDITIONS:(1)THIS DEVICEMAYNOT CAUSEHARMFUL
INTERFERENCE,AND(2) THISDEVICEMUST ACCEPTANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)

Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
TM & © 2022 VTech Holdings Limited.
All rights reserved.
IM-559400-000
Version:0