V-tech Toot-Toot Drivers 4-in-1 Raceway. User manual

Instruction Manual
4-in-1 Raceway

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
SmartPointTM Stunt Car
3 SmartPointTM
Locations
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Drivers®4-in-1
Raceway.
Get racing with the 4-in-1 Raceway by VTech®! 4 different track
configurations open up a world of racing and stunt play. Choose from
a zigzag, super long ramp, duel raceway and 2-car raceway and let
the racing commence!

3
INCLUDED IN THE PACKAGE
IJ
E
K
A
G
B
H
One SmartPointTM
stunt car
F
C D

4
•Label Sheet
•Quick Start Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please save this Instruction Manual as it contains important information.
CAUTION
This package contains small screws. Adult assembly required.
For your child’s safety, do not let your child play with the toy until it is
fully assembled.
If there are no locks inside the package, disregard this message.
Removing the Packaging Locks:
Pull out the packaging locks and discard.
Turn the packaging locks anticlockwise
several times.

5
INSTRUCTIONS
Battery Removal And Installation
Stunt Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the Stunt Car. Use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove from the unit by pulling up
on one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommendedare
to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech® cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
RECHARGEABLE BATTERIES:
• Removerechargeablebatteriesfromthetoybeforecharging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Donotchargenon-rechargeablebatteries.

7
LABEL APPLICATION
Please stick the labels to the play set as shown below:
1 1 2
334
67
7
8
9
10
5
11
12
13 14
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

8
3
1
10
5
8
11 6
12
4
14
2
9
13
7 7

9
ASSEMBLY INSTRUCTIONS
1. Insert B into A as shown below. Make sure you hear a click sound
to confirm they are firmly connected.
2. Insert C and D into A as shown below.
3. Insert E into B as shown below.
With the VTech®Toot-Toot Drivers®4-in-1 Raceway, safety
comes first. To ensure your child’s safety, adult assembly is required.