V-tech Toot-Toot Drivers Airport User manual

Instruction Manual
Airport

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
INTRODUCTION
Thank you for purchasing the Toot-Toot Drivers®Airport by
VTech®! Pack your bags and get ready for a trip into the learning
zone with the Toot-Toot Drivers®Airport! Move passengers around
the airport, take off from the runway, and then fly your jet up into the
clouds!
SmartPointTM Jet
Plastic Runway
4 SmartPointTM
locations
Cloud Platform
Roundabout
2 Mini Jets

3
INCLUDED IN THE PACKAGE
One wall One control
tower support
One control room
One control tower
base
One control
tower roof
One SmartPointTM
Jet
One leverOne radar One roundabout
base
One SmartPointTM
cloud platform
One pillar One lock

4
One SmartPointTM
track
One 3/4 track One 90-degree
track, female
One 1/4 track,
male
Two 60-degree
tracks, male
Three 1/4 tracks,
male/female
One launcher base One launcher top One end track with
plastic runway
One end track,
male
One SpotlightOne Departure Board

5
One wind metre
support
One wind metre
piece A
One wind metre
piece B
Two mini jetsOne cone One ladder
•Label Sheet
•Quick Start Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please save this Instruction Manual as it contains important information.
Adult assembly required.
Unlock the Packaging Locks
Pull out the packaging locks and discard.
Turn the packaging locks anticlockwise
several times.

6
INSTRUCTIONS
Battery Removal And Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the Jet. Use a screwdriver to
loosen the screw and then open the
battery cover.
3. If used batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside the battery box. (For
best performance, alkaline batteries or fully charged Ni-MH
rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommendedare
to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.

7
RECHARGEABLE BATTERIES:
• Removerechargeablebatteriesfromthetoybeforecharging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Donotchargenon-rechargeablebatteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech® cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

8
LABEL APPLICATION
Please stick the labels to the play set as shown below:
A1 B1 C1
12:39 LONDRES BB622 EN HORA
12:39 SÍDNEY AB731 RETRASADO
13:07 TOKIO PE831 CANCELADO
12:39 HONG KONG BB903 RETRASADO
12:39 ESTOCOLMO AB903 EN HORA
13:07 BERNA PE831 EMBARCANDO
12:39 MADRID BB621 EN HORA
12:39 PARÍS AB721
RETRASADO
13:07 SEÚL PE832 LLEGADA
12:39 BERLÍN BB902 EMBARCANDO
12:39 ROMA AB923 LLEGADA
13:07 SHANGHÁI PE851 EMBARCANDO
08:00
A11
Airport
12:39 LONDON BB622 ON TIME
12:39 SYDNEY AB731 DELAYED
13:07 TOKYO PE831 ARRIVED
12:39 HONG KONG BB903 DELAYED
12:39 STOCKHOLM AB903 ON TIME
13:07 BERN PE831 ARRIVED
12:39 MADRID BB621 DELAYED
12:39 PARIS AB721 DELAYED
13:07 SEOUL PE832 ARRIVED
12:39 BERLIN BB902 ON TIME
12:39 ROME AB923 DELAYED
13:07 SHANGHAI PE851 ARRIVED
A29
A53
Model:80-548803-003-001
P/N:92-xxxxx-000-100
Size: 188mm X 278mm
Color:4C+ UV Coating
请折叠好后交货
A51
92-xxxxx-000-100
92-007619-000-100
92-009745-xxx-100
92-xxxxx-000-100
12
3
4
678
910
5
11 12 13
14
20
15 16 17 19
18
21

9
9
5
7
2
20
14
15
16
17
13
6
3
12
4
19
11
18
10
1
8
21

10
ASSEMBLY INSTRUCTIONS
1. Assemble and attach the control tower components following the
steps below:
A. With the Control Tower Roof upside down, insert the Pillar
through the hole on the Control Tower Roof to the correct position
as shown and insert the Lock into the gap of the Control Tower
Roof to secure the Pillar to the Control Tower Roof, as shown
below.
B. Attach the Wall to the Control Tower Base and insert the
Control Tower Support, as shown below.
C. Attach the Control Tower Roof and Pillar part to the Control
Tower Base, Wall and Control Tower Support part, as shown
below. Make sure you hear a click sound to confirm the Pillar and
the Control Tower Base are firmly connected.
With the Toot-Toot Drivers®Airport, safety comes first.To ensure
your child’s safety, adult assembly is required.

11
D. Place the Cloud Platform through the Pillar, attach the Control
Room and Radar, as shown below.
2. Attach the Launcher Top to the Launcher Base, as shown below.
3. Insert the Lever to the Roundabout Base, as shown below.

12
4. Attach the Wind Metre Piece A and B together, then attach it to
the Wind Metre Support, as shown below.
5. Connect the remaining track pieces to the play set, as shown below.
Once you’ve completed the above steps, you are ready to play! You
can also connect the play set to other Toot-Toot Drivers®play sets
(each sold separately).

13
PRODUCT FEATURES
1. On/Off Switch
To turn the unit On, slide the On/Off
Switch to the On ( ) position. To
turn the unit Off, slide the On/Off
Switch to the Off ( ) position.
2. Automatic Shut-Off
To preserve battery life, the Jet will automatically power down
after approximately 45 seconds without input. The unit can be
turned on again by pressing the light up button, by pushing the
Jet quickly, or by triggering a SmartPointTM location.
Note: This product is in Try-Me mode in the packaging. After
opening the package, turn the vehicle off and on again to
proceed with normal play. If the unit repeatedly powers
down while playing, please install a new set of batteries.
ACTIVITIES
Jet
1. Slide the On/Off Switch to turn the
Jet On. You will hear a song, fun
phrases and sounds. The light will
flash with the sounds.
2. Press the Light Up Button to hear
fun sounds, songs and phrases. The
light will flash with the sounds.

14
3. Push the Jet to hear fun sounds
and melodies. If a melody is
already playing, push the Jet to
add fun sounds on the top of the
melody. The light will flash with the
sounds.
4. For added fun, the Jet interacts with the Toot-Toot Drivers®
Airport. Simply put the Jet on one of the play set’s four
SmartPointTM locations to hear fun sounds, music, phrases
and see the light flash. The Jet also interacts with the other
Toot-Toot Drivers®play sets (each play set sold separately).
ACTIVITIES
Airport
1. Place the Jet or any SmartPointTM
vehicle (each sold separately)
on any of the play set’s four
SmartPointTM locations to hear fun
sounds, music and phrases.
2. Place the Jet on the Cloud
Platform, then spin the Handle to
see the Jet fly around the tower.

15
3. Place the Jet on the Launcher and
lift the Launcher to launch the Jet
down the Runway.
4. Place the Jet or a mini jet on the
Lever, push the vehicle on the
other side to see the Jet being
pulled around.
MELODY LIST
1. Alouette
2. London Bridge
3. Little Bo-Peep
4. Row, Row, Row Your Boat
5. Old King Cole
6. Yankee Doodle
SONG LIST
Song 1
I fly best, high up in the sky.
Engines roaring, watch me fly!
Song 2
Count my engines, one and two.
Watch me fly, and speed for you!
Song 3
Watch me fly, up, up, high!

16
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On.The unit should now be ready to play with again.
5. If the product still does not work, install a brand new set of batteries.
CONSUMER SERVICES
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make every
effort to ensure the accuracy of the information, which forms the
value of our products. However, errors sometimes can occur. It is
important for you to know that we stand behind our products and
encourage you to call our Consumer Services Department with
any problems and/or suggestions that you might have. A service
representative will be happy to help you.

17
UK Customers:
Phone:03306780149(fromUK)or+443306780149(outsideUK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: [phone]
Website: support.vtech.com.au
NZ Customers:
Phone: [phone]
Website: support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED –
CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees
apply to goods and services supplied by VTech Electronics (Australia)
Pty Limited. Please refer to vtech.com.au/consumerguarantees for
further information.

TM & © 2021 VTech Holdings Limited.
All rights reserved.
IM-548800-000
Version:0
Visit our website for more
information about our products,
downloads, resources and more.
www.vtech.co.uk
www.vtech.com.au