V-tech Toot-Toot Drivers RemoteControl Racer User manual

© 2015 VTech
Printed in China
91-003063-010
User’s Manual
Remote Control Racer

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
LIGHT-UP
FACE BUTTON
DIRECTIONAL
BUTTONS
POWER
INDICATOR LIGHT
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Drivers Remote
Control Racer.
Grab the steering wheel-shaped remote control and race to victory with
the Toot-Toot Drivers Remote Control Racer! This powerful race car
will entertain your little one with playful music, fun sounds and phrases.
Use the remote control to drive the racer over SmartPoint locations to
hear fun phrases, sounds, short tunes and sing-along songs.
INTRODUCTION

33
INCLUDED IN THIS PACKAGE
• OneRemote Control Racer
• Oneremotecontrol
• Oneuser’smanual
WARNING:
All packing materials, such as tape, plastic sheets, packaging locks
and tags are not part of this toy, and should be discarded for your
child’ssafety.
NOTE:
Pleasekeepthisuser’smanualasitcontainsimportantinformation.
INCLUDED IN THIS PACKAGE
Unlock the packaging locks:
Turn the packaging lock counter-clockwise
several times.
Pull out and discard the packaging lock.

4
GETTING STARTED / BATTERY INSTALLATION
GETTING STARTED
BATTERY INSTALLATION – VEHICLE
1. Make sure the unit is turned OFF.
2. Locate the battery cover on
the back of the race car. Use a
screwdriver to loosen the screw.
3. Install 3 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (The
use of new alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY INSTALLATION - REMOTE CONTROL
1. Locate the battery cover on the back of
the remote control. Use a screwdriver to
loosen the screw.
2. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
3. Replace the battery cover and tighten
the screw to secure.

5
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com
BATTERY NOTICE

6
PRODUCT FEATURES
PRODUCT FEATURES
1. OFF/MODE SELECTOR SWITCH – VEHICLE
To turn the unit ON, slide the OFF/
MODE SELECTOR SWITCH to t h e
REMOTE CONTROL MODE ( )
or STANDARD MODE ( ) position.
To turn the unit OFF, slide the OFF/
MODE SELECTOR SWITCH to the
OFF ( ) position.
2. CHANNEL SELECTOR SWITCH
To allow the Remote Control Racer and remote control to function
together, slide the CHANNEL SELECTOR SWITCH ( ) to
the same location on the Remote Control Racer and remote control.
Note: If two or three Remote Control Racers are operating in the
same vicinity, place each unit on a different channel ( ).
(A maximum of three Remote Control Racers can operate in
one location.)
3. FORWARD/BACKWARD BUTTONS
In REMOTE CONTROL MODE, press the FORWARD
BUTTON or BACKWARD BUTTON on the remote to make
the race car go forward or backward. (The effective distance
for the race car to recognise the remote control is 9 ft. to 18
ft. The distance will be shorter when the batteries are low.)

7
For your child’s safety, only use the motorised car on Toot-
Toot Drivers play sets. Do not roll the car on your clothing,
body or hair while the motorised car is turned on. If something
gets caught in the car’s wheels while the motor is on, lift
the car up so it is no longer touching your child or slide the
mode selector switch to the off position to turn off the motor.
4. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech®Toot-Toot Drivers Remote
Control Racer will automatically power down after approximately
60 seconds without input in STANDARD MODE and 120
seconds in REMOTE CONTROL MODE. In STANDARD MODE,
the unit can be turned on again by pressing the light-up face
button or pushing the vehicle. In REMOTE CONTROL MODE,
press the light-up face button or turn the unit off and on to turn
the unit on. (The remote control cannot wake up the race car.)
Note: The Remote Control Racer is in try-me mode in the packaging.
After opening the package, turn the vehicle off and on again to
proceed with normal play.
Note: For optimal performance, keep your Toot-Toot Driver Remote
Control Racer indoors and out of direct sunlight.
PRODUCT FEATURES

8
ACTIVITIES
1. Slide the race car’s OFF/MODE
SELECTOR SWITCH to either
REMOTE CONTROL MODE or
STANDARD MODE to turn the
race car ON. You will hear a song,
a phrase and sounds. The light-up
face button will flash with the sounds.
2. Press the light-up face button to hear
race car sounds, songs and phrases.
The light-up face button will flash with
the sounds.
3. When the race car is in STANDARD
MODE, push the race car to hear
fun sounds and melodies. While a
melody is playing, push the vehicle
again to add in fun sounds on top of
the melody. The light-up face button
will flash with the sounds.
4. For remote control play, turn the
race car to REMOTE CONTROL
MODE ( ). To drive the race
car with the remote control, put
both items on the same CHANNEL
SELECTOR SWITCH number.
Once both items are on the same
channel, press the forward or
backward button on the remote for
some racing fun!
ACTIVITIES

9
5. Operate up to three vehicles at once by putting each Remote
Control Racer on a different channel number using the CHANNEL
SELECTOR SWITCH! (Each Remote Control Racer sold
separately.)
6. For added fun, the Remote Control Racer interacts with other
Toot-Toot Drivers play sets. Simply roll or navigate the race car
overoneoftheplayset’sSmartPoint locations to see the light
flash and to hear greetings, fun sounds, short tunes and sing-along
songs (each play set sold separately).
SING-ALONG SONG LYRICS
SONG 1
3, 2, 1,
I’maracecar,
Join my team,
Grab the remote,
We can win first place!
SONG 2
One lap left,
Finish the race.
Vroom, vroom, vroom.
SONG 3
Safety belt on,
Let’swintherace.
Vroom, vroom, vroom.
MELODY LIST
1. Big Rock Candy Mountain
2. This Old Man
3. Hey Diddle Diddle
4. Chop Sticks
5. Can Can
6. On Top of Old Smokey
SING-ALONG SONG LYRICS / MELODY LIST