V-tech Toot-Toot Drivers Garage User manual

User’s Manual
© 2013 VTech
Printed in China
91-002594-020 UK

3
Introduction
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Drivers Garage
learning toy.
The Toot-Toot Drivers Garage is a fun interactive toy for little ones to
enjoy! Drive the cute Tow Truck around the garage to trigger lots of fun
responses and interactive phrases about the petrol station, car wash,
turntable and exit gate. There’s even a magic sensor and 6 SmartPoint
locations that will recognise different Toot-Toot Drivers vehicles. Roll
the Tow Truck down the winding ramp for extra fun! With realistic
sounds, cute songs and phrases learning has never been so much fun!
MODE SELECTOR
LIGHT-UP
BUTTONS
ELEVATOR
TURNING
DISC
6 SMARTPOINTTM
LOCATIONS
RECOGNITION
SENSOR
TOW TRUCK
SPIRAL
RAMP

4
Included In This Package
INCLUDED IN THIS PACKAGE
One main unit
One checkpoint sign One trafc stop
Three helicopter pad pieces
One tow truck
Two spiral ramp tracks
One instruction manual
One support

5
Getting Started
WARNING: All packing materials, such as tape, plastic sheets,
packaging locks and tags are not part of this toy, and
should be discarded for your child’s safety.
Note: Please keep this instruction manual as it contains
important information.
Unlock the packaging locks:
Rotate the packaging lock 90
degrees anit-clockwise
Pull out the packaging lock
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the main unit and the bottom of the
tow truck. Use a coin or screwdriver to
loosen the screws.
3. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
main unit battery box (a). Install 2
new AAA (AM-4/LR03) batteries
following the diagram inside the tow
truck battery box (b). The use of new
alkaline batteries is recommended for
maximum performance.
4. Replace the battery covers and tighten
the screws to secure.

6
Assembly Instructions
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in re.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
DO NOT USE RECHARGEABLE BATTERIES.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specied value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com

7
Assembly Instructions
ASSEMBLY INSTRUCTIONS
With the VTech®Toot-Toot Drivers Garage safety comes rst. To
ensure your child’s safety, adult assembly is required.
1. Insert the trafc stop into the slot on
the bottom-left of the main unit.
2. Insert the checkpoint sign into the slot
on the top-left of the main unit.
3. Insert the two sides of the helicopter pad into the corresponding
slots on the helicopter pad platform (a). Then, insert the entire
helicopter pad into the corresponding slots on the main unit (b).

8
Product Features/Activities
4. Put the top spiral ramp track on top of the bottom spiral ramp track,
joining the two tracks in the centre (c). Then, twist the top spiral ramp
track to lock it to the bottom spiral ramp track (d). Finally, attach the
assembled spiral ramp to the top and bottom of the main unit (e).
5. Insert the support into the slot on the
underside of the turning disc platform.
PRODUCT FEATURES
1. MODE SELECTOR
To turn the unit ON, slide the MODE
SELECTOR to the Learning Mode
() or Music Mode position ( ).
To turn the unit OFF, slide the MODE
SELECTOR to the OFF position ( ).
2. SMARTPOINTTM LOCATIONS
The Garage play set includes 6
SmartPointTM locations that can be
recognised by Toot-Toot Drivers
vehicles to trigger fun sounds, phrases
and music. (SmartPointTM vehicles
only, sold separately.)

9
Activities
3. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech®Toot-Toot Drivers Garage will
automatically power-down after approximately 30 seconds without
input. The unit can be turned on again by pressing any button.
ACTIVITIES - GARAGE
1. Slide the mode selector to turn on the
unit. You will hear a sing-along song,
phrase and sounds in Learning Mode.
In Music Mode, you will hear a fun
phrase, a sing-along song and sounds.
The lights will ash with the sounds.
2. Press the three light-up buttons to
learn colours and about the weather
in Learning Mode. In Music Mode,
hear phrases, sounds and melodies.
The lights will ash with sounds.
3. Push a vehicle over one of the 6
SmartPointTM locations to hear the
vehicle play a related phrase, sound
or melody. (SmartPointTM vehicles only,
sold separately.)
4. Put a vehicle on the elevator platform.
Move the elevator to learn opposites in
Learning Mode. You’ll hear sounds in
Music Mode. The lights will ash with
the sounds.

10
Activities/Melody List
5. Put a vehicle on the turning disc. Turn
the disc to hear sounds, phrases and
sing-along songs in Learning Mode.
Hear sounds, phrases and melodies in
Music Mode. The lights will ash with
the sounds.
6. While a vehicle is on the recognition
sensor, press down or quickly push
the vehicle through the gate to hear a
greeting. The lights will ash with the
sounds.
ACTIVITIES - TOW TRUCK
1. Slide the ON/OFF SWITCH to the ON
position to turn the unit ON. You will hear
a song, a phrase and sounds. The light will
ash with the sounds.
2. Press the LIGHT-UP BUTTON to hear
vehicle sound effects, a song and phrases.
The light will ash with the sounds.
3. Push the vehicle to hear fun sounds, a song
and short tunes. While the short tune is
playing, push the vehicle again to stop the
short tune and play it with a faster tempo.
The light will ash with sounds.