6
Release 11/21
ArmorBua™MASH TL3 Temporary End Treatment
4.0 Preparation
4.1 Foundation
The ArmorBua™ system is designed to perform on a
variety of foundations including concrete, asphalt, and
any other surfaces capable of bearing the weight of the
system.
Uneven surfaces should be attened, and large debris
removed from the foundation prior to installation.
Cross slopes of up to 8% (5° or 1:12 slope) can be
accommodated with the standard hardware and the
instructions provided in this manual. For slopes in
excess of 8%, contact Ingal Civil Products.
4.2 Transition
ArmorBua™ is designed to accommodate a temporary
F-Type concrete barrier.
Placement and installation of the ArmorBua™
system must be accomplished in accordance with the
Austroads Design Guide and ASBAP and other state
and local standards.
Before installing the ArmorBua™ system, ensure that
all the materials required for the system are on site and
have been identied.
5.0 Documentation
Prior to installation and assembly of the ArmorBua™
system, ensure you have read and understand the
installation and assembly instructions. The following
items should be reviewed and understood prior to
installation.
Installation and Assembly Manual (check for current •
revision posted at www.ingalcivil.com.au).
System Drawings (check www.ingalcivil.com.au for•
current revision, located in installation manual).
6.0 Important Notes
Sign Convention•
The term Front = At the Nose Plate
The term Rear = At the Transition
This manual follows installation steps for a•
complete ArmorBua™ system that is installed on
site or relocated to another location.
See Page 16 for water lling instructions.
In regions where the water lled
elements could become frozen,
appropriate anti-freeze solutions
should be used.
Failure to do so will result in improper
performance of the system and may
cause serious bodily injury.
Care should be taken to ensure that appropriate Anti
-Freeze solutions are used in accordance with federal,
state, and local requirements.
7.0 Anchoring Specications
The ArmorBua™ system uses chemical set M20
8.8 grade threaded rod for anchoring to temporary
concrete barrier.
