Vantron G202 User manual

Vantron | Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
G202 | Quick Installation Guide www.vantrontech.com
G202 Industrial Edge Computing Gateway
Quick Installation Guide
Version: 1.1
© Vantron Technology, Inc. All rights reserved.

Vantron | Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
G202 | Quick Installation Guide www.vantrontech.com
1. COMPONENT CHECKLIST
Check if all components are available:
•Gateway
•4G LTE antenna / Wi-Fi & BT antenna
•Power adapter
•Power cable
•DIN rail mount bracket / wall mount
bracket
Note: Actual accessories might vary slightly
from the list above as the customer order might
differ from the standard configuration options.
2. INSTALL THE GATEWAY (DIN rail mount for
illustration)
•Hold the gateway vertically;
•Place the gateway on a fixed DIN rail and fit
the clamp of the bracket (the spring inside)
into one side of the DIN rail;
•Push the gateway in such a way as to
compress the spring till there is enough
space for the latch of the bracket (non-spring
side) to fit the other side of the DIN rail
properly.
Note: The DIN rail mount bracket is pre-
installed on the gateway before shipment.
3. INSTALL THE ANTENNAS
•Install the round head antennas to the
WLAN antenna connectors;
•Install the flat head antennas to the LTE
antenna connectors;
•Tighten the rotating heads to secure
the antennas in proper position.
4. INSTALL THE SIM CARD
•Insert an activated SIM card into SMI1
slot with the gold-colored contacts
facing down, or, insert into SIM2 slot
with the gold-colored contacts facing
up;
•Push the SIM card to secure it.
Note: Installing the Micro SD card is literally
the same as installing the SIM card, and users
need only to install the Micro SD card into
corresponding slot with the gold-colored pins
facing up.

Vantron | Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
G202 | Quick Installation Guide www.vantrontech.com
5. ETHERNET CONNECTION
There are two Ethernet ports on the gateway.
•Connect the WAN port of the gateway to a
live Ethernet port before connecting any
client device, or skip this if you use cellular
data for network connection;
•Plug one end of the Ethernet cable into the
LAN port on the gateway;
•Plug the other end of the Ethernet cable into
the open port on a client device.
6. POWER SUPPLY
•Connect the terminal connector of the
power cable to the terminal block of the
gateway, and the other end to the power
adapter;
•Plug the adapter into a 9~36V DC power
outlet;
•The power indicator will turn solid green
upon power application.
7. WARNING
Do not install the product on top of any
other electrical equipment or place any
other equipment on top the product.
Keep the product away from any heat
sources such as direct sunlight, heaters,
radiators, or other A/V receivers or
devices that emit heat.
Failure or improper selection or improper
use of the product described herein or
other related items may cause death,
personal injury or property damage.
Vantron Technology, Inc.
Address: 48434 Milmont Drive, Fremont, CA 94538
Tel: [phone]
Email: [email protected]