Vaporesso GEN PT80 S User manual

USER
MANUAL
VAPORESSO GEN PT80 S

1ENGLISH
Thank you for choosing Vaporesso product. Please read
this instruction carefully before use to ensure a perfect
experience.
If there is any additional requirement about this product,
please consult the local agent or contact us through our
website: www.vaporesso.com
Dimensions: 132 x 30 x 29 mm
POD Capacity: 4.5ml/2ml(TPD)
Coils & Suggested Wattage:
GTX 0.15Ω MESH Coil (60-75W)
GTX 0.3Ω MESH Coil (32-45W)
Battery Capacity: 1 x 18650(Not Included)
Output Power: 5-80W
Charging Current: DC 5V/2A,Type-C
Battery Display: 0.91’’ OLED Screen
ENLARGED VIEW
SEPCIFICATION
Drip Tip
Top Cap: Air-inlet Port & Relling Port
Coil
Power Button
0.91” OLED Screen
“+” Button
“-” Button
Type-C USB Port
ENGLISH

2ENGLISH
Figure 1
Figure 2
1 x VAPORESSO GEN PT80 S MOD
1 x VAPORESSO XTANK POD (4.5ml/2ml TPD)
1 x GTX 0.15Ω MESH Coil (In-box)
1 x GTX 0.3Ω MESH Coil (In-box)
1 x Type-C Cable
1 x User Manual
1 x Warranty Card
PACKING LIST

3ENGLISH
Figure 3
1
4
2
5
3
1. Install the POD
Install the POD onto the battery at the correct place. Make
sure they are rmly connected.
* Refer to the gure 1 above.
2. Replace the Coil
- Take out the POD from the battery;
- Pull out the used coil from the POD;
- Install a new coil to the POD;
- Reattach the POD into place.
* Refer to the gure:2 above.
3. Fill E-liquid
- Twist the top cap according to the arrow direction until
the relling port show out;
- Pull out the silicone plug and ll e-liquid through the hole,
then twist the top cap in place after lling is nished.
- Please wait 5 minutes for the e-liquid to soak into the coil
completely.
* Refer to the gure 3 above.
4. Adjust the Airow
To adjust the airow volume, please rotate the top cap on
the POD.
USE INSTRUCATIONS

4ENGLISH
PROTECTIONS
5. Power on the Device
Click the power button 5 times in 2 seconds to power on or
power o the device.
6. Power Adjustment
GEN PT80 S is using the powerful GTX coil platform, and
the suggested power need to be noticed before start
vaping.
7. Start Vaping
Press the power button to enjoy extraordinary vaping
experience.
8. Charge the Battery
After connecting the Type-C cable to the battery, the battery
indicator and remaining charging time will be showed on
the screen.
9. Settings
SYSTEM LOCK/UNLOCK: Press power button 3 times.
PUFF: To clear the pu counter, please press power button
and “-” button;
Flip Screen: To ip the screen direction, please press power
button and “+” button.
Press “+”and “–” buttons together to enter the setting
interface.
VW: Wattage adjustment mode;
VV: Voltage adjustment mode;
SMART VW: The power of device will be adjusted
automatically according to the coils;
DEFAULT: Restore factory settings;
EXIT: Back to main interface.
GTX MESH Coils GTX 0.15Ω MESH GTX 0.3Ω MESH
Suggested Power 60-75W 32-45W
Protections Situation
USB Input Protection The USB input voltage is too high.
Low Battery Protection The battery drops too low.
No Load Protection The device detects no cartridge on
the battery.
Short-circuit Protection The device detects a short circuit.
Overtime Protection Constantly vape for more than 10
seconds.
Overheat Protection The device detects an overheated
PCBA.

5ENGLISH
This refillable electronic cigarette is intended for use
with compatible e-liquid, which may contain nicotine.
Nicotine is an addictive substance and it is not suitable or
recommended to use in following cases:
1. This device is not suitable for:
- Persons under the legal smoking age.
- Persons experiencing heart disease, stomach or duodenal
ulcers, liver or kidney problems, long-term throat disease or
dicult breathing due to bronchitis, emphysema or asthma.
- Persons with an overactive thyroid gland or experiencing
WARNING
CAUTIONS
1. Please turn o the device when it is not in use.
2. Do not leave the charging device unattended.
3. Do not drop, throw or abuse your device, which may
cause damage.
4. Please use a standard USB output charger with proper
charging current and voltage range.
5. Keep away from the water or any ammable gas, liquid .
6. Do not expose the device to direct sunlight, dust,
moisture or mechanical shock.
7. Do not expose the device to extreme temperature.
(Recommended temperature range: -10~60 ℃ /14~140 ℉
while using and -10~45℃ /14~113 ℉while storing).
8. EEE Recycling: the product should not be treated as
household waste, instead, it should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment.
9. Battery Recycling: the product battery should not be
treated as household waste, instead, it should be handed
over to the applicable used battery collection point for
recycling.
10. Only have your device repaired by Vaporesso. Do not
attempt to repair it by yourself as damage or personal injury
may occur.
11. Do Not use batteries with broken surface, overheating,
leakage and strange odor;
12. Charge the battery indoors only;
13. Recycle batteries in accordance with local laws and
regulations.
14. Please use high-rate discharge batteries(≥25A).

6ENGLISH
phaeochromocytoma (a tumour of the adrenal gland that
can aect blood pressure).
- Persons taking certain medications like Theophylline,
Ropinirole or Clozapine and etc..
2. This device is not recommended for
- Non-smokers
- Pregnant or breastfeeding women
3. You may experience the following results if you use
nicotine containing e-liquid with this product. If it happens,
please consult a healthcare professional and show them
this leaet if possible:
Feeling faint/Nausea /Dizziness/Headache /Coughing/
Irritation of the mouth or throat/Stomach discomfort/
Hiccups/Nasal congestion/Vomition/Chest palpitations/pain
or an irregular heart rate
This device should not be used by
persons under the legal smoking age.