Vaporesso XIRON User manual

User Manual
VAPORESSO XIRON

1
English
Thank you for choosing Vaporesso product. Please read this
instruction carefully before use to ensure a perfect experience.
If there is any additional requirement about this product, please
consult the local agent or contact us through our website:
www.vaporesso.com
ENGLISH
EXPLODED VIEW
SPECIFICATIONS
Mouthpiece
Air-inlet Ring
Power Button
0.69’’ OLED Screen
“-” Button
“+” Button
USB Port
Dimensions 46.5x27.8x93.0mm
POD Capacity 2ml / 5.5ml
Coil GTX 0.3Ω MESH Coil (32-45W)
GTX 0.8Ω MESH Coil (12-20W)
Battery Capacity Built-in 1500mAh
Display 0.69’’ OLED Screen
Output Power 5-50W
Charging Current DC 5V/2A, Type-C

2English
USE INSTRUCTIONS
1. Install or replace the coil
Pull out the pod and then pull out the used coil. Install a new
one rmly. Reattach the pod back into place.
2. Fill the E-liquid
Pull out the silicon plug on top. Fill the e-liquid through the
slot. Reattach the silicon plug back into place. If it’s your rst
time lling the e-liquid of this pod, please wait for 5 minutes
for the e-liquid to soak into the coil.
3. Adjust the Airow
To adjust the airow volume, please rotate the air-inlet ring on
the side of the battery.
4. System Operating
(1) Power on/off: press the power button 5 times in 2s.
(2) Lock/unlock the Buons: press the power button 3 times
continuously to lock or unlock the “+” button and “-” button.

3
English
PROTECTIONS
(3) Start Vaping: press and hold the power button to start
vaping. For your safety, please do not vape for more than 5
seconds at a time.
(4) Adjust the Power: press the “+” button or “-” button to
adjust the power.
(5) Flip the Screen: press the power button and “+” button
simultaneously to ip the screen 180°.
(6) System Setting: press the “+” button and “-” button
simultaneously to enter the system setting interface, which
includes STAMRT VW, VW, VV, DEFAULT and EXIT.
VV: select “VV” and press the power button to enter VV mode.
VW: select “VW” and press the power button to enter VW
mode.
SMART VW: select “SMART VW” and press the power button to
enter ON/OFF setting.
DEFAULT: select “DEFAULT”, “YES” and press the power button
to restore the factory setting.
(1) Overtime Protection: the device will stop working if you
vape for more than 5 seconds at a time, and “OVER TIME” will
show on the screen.
(2) Low Resistance Protection: when an extremely low
resistance is detected, the device will stop working and show
“LOW ATOMIZER” on the screen.
5. Charge the Baery
Connect the device and the standard charger via Type-C cable.

4English
(3) High Resistance Protection: when a high resistance is
detected, the device will stop working and show “HIGH
ATOMIZER” on the screen.
(4) No-load Protection: when there is no coil detected, the
device will stop working and “CHECK ATOMIZER” will show on
the screen.
(5) Short-circuit Protection: when a short-circuit is detected,
the device will stop working and “SHORT ATOMIZER” will show
on the screen.
(6) Low Voltage Protection: when the battery voltage is too
low to start vaping, the device can not be operated and “LOW
BATTERY” will show on the screen.
(7) Over Discharge Protection: when the battery voltage is
extremely low during vaping, the device will stop working and
“LOW BATTERY” will show on the screen.
(8) Over Charge Protection: the device will stop charging when
it is fully charged.
(9) USB Input Protection: when the USB detects an input
voltage exceeding the rated voltage, the device will stop
charging.
CAUTIONS
1. Please turn off the device when it is not in use.
2. Do not leave the charging device unattended.
3. Do not drop, throw or abuse your device, which may cause
damage.
4. Please use a standard USB output charger with proper
charging current and voltage range.
5. Keep away from the water or any ammable gas, liquid.
6. Do not expose the device to direct sunlight, dust, moisture
or mechanical shock.
7. Do not expose the device to extreme temperature.
(Recommended temperature range: -10~60℃ /14~140 ℉while

5
English
using and -10~45℃ /14~113 ℉ while storing).
8. EEE Recycling: The product should not be treated as
household waste, instead, it should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment.
9. Battery Recycling: The product battery should not be treated
as household waste, instead, it should be handed over to the
applicable used battery collection point for recycling.
10. Only have your device repaired by Vaporesso. Do not
attempt to repair it by yourself as damage or personal injury
may occur.
WARNINGS
This rellable electronic cigaree is intended for use with
compatible e-liquid, which may contain nicotine. Nicotine is an
addictive substance and it is not suitable or recommended to
use in following cases:
1. This device is not suitable for:
- Persons under the legal smoking age.
- Persons experiencing heart disease, stomach or duodenal
ulcers, liver or kidney problems, long-term throat disease or
difcult breathing due to bronchitis, emphysema or asthma.
- Persons with an overactive thyroid gland or experiencing
phaeochromocytoma (a tumour of the adrenal gland that can
affect blood pressure).
- Persons taking certain medications like Theophylline,
Ropinirole or Clozapine and etc..
2. This device is not recommended for:
- Non-smokers
- Pregnant or breastfeeding women
3. You may experience the following results if you use nicotine
containing e-liquid with this product. If it happens, please
consult a healthcare professional and show them this leaet if
possible:
- Feeling faint - Nausea - Dizziness - Headache
- Coughing - Irritation of the mouth or throat
- Stomach discomfort - Hiccups
- Nasal congestion - Vomition
- Chest palpitations/pain or an irregular heart rate
This device should not be used by
persons under the legal smoking age.