Vaquform DT2 User manual

QUICK START
GUIDE

A B C D
1Remove the top foam. Set
aside the handlebar, tool kit,
and accessories. 2
Lift the Vaquform from the front
and back of the heater. Set it on a
flat surface then remove the foam
and strap.
3Remove the plastic sheets.
Set aside.
EUNBOXING

HEATER
MAGNETS
A(M3 x 12)
x4
TEST FORM
1Unlock the toggle clamp
2Lift the upper sheet clamp frame
then remove the test form.
3Return the upper sheet clamp
frame
4Lock the toggle clamp
Attach four magnets to the heater following the
diagram below.
x6 x6 2mm x1

HANDLEBAR MESH & FILTER
(M6 x 25)
B
x2 x2 5mm x1
1Lock the linkage.
2Screw the handlebar onto the linkage and
the shoulder cap.
x2
1Raise the handlebar then remove the mesh
from the plastic.
2Place a filter on the second vacuum port.
Return the mesh on top of the platen.
C
x5
Please read the full manual before
operating the machine.
ASSEMBLY
COMPLETE

©2019
All Rights Reserved
Vaquform, Inc.
[phone]
9410 Owensmouth Ave,
Chatsworth, CA 91311,
USA
www.vaquform.com