U-Line S-1135 User manual

PAGE 1 OF 2 0316 IS-21135
πS -21135
5-GALLON LEVER
LOCK LID
1-800-295-5510
uline.com
INSTRUCTIONS
CLOSING INSTRUCTIONS
1. Place the cover on the pail. Press down along the
edges and in the center of the cover to ensure that it
is seated properly. (See Figure 1)
2. Before placing the lever lock ring on the pail, it must
be oriented correctly. There is an "Up Indicator" with
an arrow stamped into the base of the handle. Orient
the ring with the arrow pointing up. (See Figure 2)
3. Open the lever lock ring as wide as possible, then slip
it over the pail. Be sure that the ring is placed on the
pail in a manner that allows it to be closed by moving
the lever clockwise onto the ring. (See Figure 3)
4. Orient the lever on the ring to be the opposite of the
seam weld (180 degrees from the seam weld).
5. Apply downward pressure to the cover and release
the lever, allowing the ring to slide onto the cover/
curl edge. (See Figure 4)
NOTE: The ring must encompass the cover/curl
around the entire edge of the pail.
Figure 1
Ring Seal Cover Properly Seated
Base of
the Handle
Up Indicator
UP
Figure 2
Ring Seal Cover
Lever Lock Ring
in Open Position
Figure 3
Ring Seal
Cover
Lever Lock Ring
Cover/Curl Edge
Figure 4

PAGE 2 OF 2 0316 IS-21135
6. Close the ring clockwise by applying pressure to the
lever until it collapses onto the ring. (See Figure 5)
7. Insert the tamper-evident T-clip through the slot in
the lever. This will hold the lever in place. The T-clip
should also pass through the loop attached to the
body of the ring. (See Figure 6)
NOTE: A locking mechanism can be inserted
into the eyelet of the latch to make the lever
tamper-evident. (See Figure 7)
8. If the ring is locked properly, it cannot be rotated or
moved. If the ring slides, it is oversized.
INSTRUCTIONS CONTINUED
Clockwise
Direction
Lever Lock Ring
Figure 5
Slot
Lever
T-Clip
Figure 6
Lever
Eyelets
T-Clip Bent
Over Lever
Figure 7
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com