Varytec Mini LED Strobe User manual

User manual
Mini LED Strobe
1. Safety instructions
•
This unit is only for indoor use (not outdoor) allowed.
•The warranty is void with manual modification of the device.
•Only be repaired by trained professionals.
•Only use fuses of the same type and only original parts as spare parts.
•To prevent fire or electrical shock, do not expose this appliance to rain or moisture.
•Unplug the power cord before you open the case.
1.1. FOR SAFE AND EFFICIENT OPERATION
Beware of heat and extreme temperatures!
Place the unit in a location where it is not exposed to extreme temperatures, moisture or dust.
Operate the device only in an ambient temperature between 5°C (41°F) - 40°C (104°F). Do not place
the device in direct sunlight or heat sources.

2 / 2
Protect the device from moisture, water and dust!
The device should be installed only in places where is no humidity. Do not place liquids on or near the system.
If the device is not working properly!
The user should not attempt to service the appliance yourself. All repairs and service work should be carried out by a qualified
Technician.
Handle the power cord with care!!
Never pull on the cord to disconnect the unit from power!
If you do not use the unit for a long period of time, unplug the power cord from the can.
Health risks:
Never look directly at the strobe light, because that can cause epileptic seizures.
CAUTION!
The warranty will not apply to damage caused by not following the instructions. The manufacturer and importer to be
responsible for consequential damages resulting from any liability. Only qualified and trained technicians should perform
the proper electrical connection.
All electrical and mechanical connections must be installed in accordance with European safety standards
.
2. Commissioning
Important:
This equipment has been tested several times by the manufacturer and is therefore technically in perfect condition.
Please observe all safety instructions contained in this user manual to avoid any risk.
Connect the device to the power supply. Use the dial on the back of the unit to set the strobe speed.
3. Technical data
Power supply 230V/50Hz
Total encumbrance 3W
LED quantity 21 LEDs
Weight 0,5 kg
Dimensions 85x135x185mm