VeGue VS-0808 User manual

Trouble shooting guide
Product features
Charging instructions
Common function description
Vol：Adjust volume
Treble：Adjust treble
Bass： Adjust bass
Mic Vol：Adjust microphone volume
Echo：Adjust echo
Mic：Wired microphone input
When charging, connect the supplied power adapter to AC 90V-240V~ for charging. The
charging time should be 6 ~ 8 hours. After being fully charged, unplug the power supply to avoid
damage to the battery due to long-term charging.
Battery level indicator: There is a battery level indicator on the display.
When the battery power is low, the entire power indicator icon will flash,
so please charge in time. When charging, the battery indicator icon will
flash. After the flashing stops, the battery should continue to charge for
1 ~ 2 hours, which can prolong the battery life.
Note: If the battery is used out, please recharge the battery within 48 hours.Do not leave
the empty battery for a long time, otherwise the battery will be damaged.
Main technical specifications
Output power-----------------------------------
Input sensitivity-----------------------------
SNR-----------------------------------------
Frequency response------------------------
Power supply----------------------------
250W
500±30mV
≥65dB
26Hz~18KHz
AC 90V-240V~
Instruction Manual
*Above specifications are the specifications of the sampling machine and are for reference purpose only.
*Because of continuous product improvement.specifications will keep changing at any time without prior
notification.
This system can be used with PC, DVD, VCD, MP3, Electronic Piano and any device with
audio output.
The amplifying circuit is designed with high performance and high fidelity, and equipped with
professional and high quality speaker, it can make the sound field positioning clear and layered.
The system voice effect is outstanding, the bass is surging and shocking, the middle tone is
strong and bright, the treble is crisp and pleasant.
Professional electronic frequency division circuit, so that the division point of the machine more
accurate, better effect.
The use of professional design and manufacture of large capacity batteries, as well as audio
power supply capacitor makes the local power reserve margin more larger,more stable,better
dynamic,higher SNR.
VS-0808VS-0808VS-0808
Portable SpeakerPortable SpeakerPortable Speaker
Common
problems Possible Cause Solution
There is
no sound
when
power is
on
Distortion
of sound
Mic
is silent
MP3
is silent
1. No input source.
2. The main volume is at the
minimum position.
1. Use better music signals.
2. Adjust the volume appropriately.
1.Turn down the main volume.
2. Check whether the speaker is
damaged or not.
If it so, it needes to be repaired.
1.Volume is adjusted to max.
2.Speaker may be damaged.
1.USB song format is wrong.
2. Improper operation leads to
procedural chaos.
3. The USB/TF card is not
inserted properly.
1. Convert the format to MP3.
2. Restart the machine.
3. Unplug and re-plug into
the USB/TF card.
1. The microphone switch is not
on.
2. Mic volume is at 0 position.
3. Low battery of wireless
microphone.
1. Turn on the microphone switch.
2. Adjust the microphone volume
appropriately.
3. Replace the wireless microp-
hone battery.

Remote control instructions Description of controls
Rear panel instructions
*Image diagram, for reference only*Image diagram, for reference only
*Image diagram, for reference only
1. Mute
2. Song serial number
3. Input selection
4. The volume +
5. Next
6. The volume -
7. Sound field effect
8. Next file
9. Previous file
10.Recording
11. Play the record
12. PREV
13. Play/Pause
14. The light switch
15. Repeat
Guitar
USB/TF
Microphone controls and basic operation
Guitar jack: Connect guitar.
Guitar Volume: Adjust the guitar volume.
1. The TF interface
2. Bass volume
3. The USB interface
4. Treble volume
5. Audio output
6. Audio input
7. Adjust microphone volume
8. Guitar input
9. Echo
10. Microphone 1 input
11. Guitar volume
12. Microphone 2 input
13. Recording/Recording playback
14. PREV
15. Play/pause
16. NEXT
17. Mode selection
18. Light switch
19. Microphone priority
20. Play on loop
21. Adjust volume
22. The screen
1.Under normal circumstances, the remote control should be
used within a range of about 20 feet and 30 degrees from the
remote reception window.
2.When operating the remote control, point the remote
control at the receiver window of the machine. There should
be no obstacles between the remote control and the
machine.
3.If the receiving window is in the position of strong light, the
remote control may fail. In this case, please remove the
machine to avoid direct exposure to strong light.
4.Please don't make both new and old batteries work
together,and regularly check whether the remote control
batteries need to be replaced.
Music files in USB and TF cards should be formatted as FAT32 on the computer.
The order about music play is based on file name,if the music file names are as
"01,02,03"in sequence.This product will play the file "01"first.
Copy MP3 or WMA music files to USB/TF cards. It is recommended to delete
unnecessary files and folders to speed up card reading and reduce card reading problems
Recording function
Bluetooth operation
Play function
USB port: insert USB and play music.
TF port: insert TF card and play music.
Supports MP3, WMA, and WAV music formats, outstanding sound performance, high fax
stereo design.
M: to switch external audio, MP3 / Bluetooth functions.
►||: press this key to pause the music, and press again to continue.
|◄◄ / ►►|: when playing, select the PREVIOUS/NEXT music.
Bluetooth connection method:Turn on the speaker,press the‘M’key on the
speaker panel,and the screen will show ‘BLUE’.Use your phone to connect the
Bluetooth of the speaker.The Bluetooth name is VS-0808.
If the connection fails,please restart the device or the phone and try again.
The use range of the Bluetooth is 32ft in the open area.
1.Power switch
2.AC 90V-240V~
3.Light switch
4.DC 12V IN
1 2 43
Risk of electric shock do not open.
It is a normal phenomenon that the machine is
heated during operation hot surface do not touch.
WARNING
1.Microphone on
2.Microphone off
3.Screen
1
2
3
20 feet
Please insert USB or TF card first and then press“●/►···” into recording
mode. When recording music at the first time, an new file “RECORD" will be
created in the card and all recordings will be saved into the file. These
recording files are automatically named as“FILE0000, FILE0001……” in
sequence. When recording music, press“●/►”to puase it and press again
to continue. Press“M” or“●/►”to quit recording mode.
Please press “●/►” into recording-play mode(automatically play the
musics recording before). Usually the machine will play the last recording
music first. Press PREV( |◄◄) or NEXT( ►►|) to select the music. Press
Replay on the remote control to replay music. If you would like to replay single
music or all musics, please press Replay repeatedly.