Verkada BC51 User manual

Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
Install Guide
BC51 Alarm Console

Document
Document Details
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
V1.0 (20220624)
(V1.0 first published 20220624)
Firmware
Firmware version can be verified on
Verkada Command command.verkada.com.
2

Introduction
What’s in the box
What you’ll need
●A working internet connection
●A smartphone or laptop
●1/4 inch (6.5mm) drill bit for wall anchors
●1/8 inch (3mm) drill bit for pilot holes
●A Cat5 or Cat6 ethernet cable
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
BC51 Alarm Console
3
T10 Security L key
Wall Screws and Wall Anchors
Connect
For easy registration and setup, scan
the QR code on the product.
If you prefer to manually register your
product, please proceed to:
verkada.com/start

Installation
Remove mount plate
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
4
Unscrew two security screws with the
L key provided in the box.
Remove mount plate by sliding it
down and out.

Installation
Connect
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
5
For easy registration and setup, scan
the QR code on the product.
If you prefer to manually register your
product, please proceed to:
verkada.com/start
Connect ethernet cable to
PoE adaptor.

Installation
Mounting
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
6
Mount plate details
Use the mount plate as a template,
and mark the correct hole pattern.
A Wall mount
B Single gang junction box
European junction box
3.5’’ Round junction box
C 4’’ Round junction box
Route ethernet cable through the center
hole. Secure mount plate by using
provided drywall anchors and screws.
If you are routing the cable along the
wall, loop the cable through the center
cutout on mount plate.

Installation
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
7
Mounting
Make sure your ethernet cable is
connected to PoE adaptor.
Tighten two screws on the bottom to
secure the device.
Push your BC51 against mount plate
and slide it down to engage all the
mounting hooks.

Appendix
Support
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
Thank you for purchasing this Verkada product. If for any reason
things don’t work right, or you need assistance, please contact us
immediately.
verkada.com/support
Sincerely, The Verkada Team
8