Verus Engineering A0158A User manual

Hood Louver Rain Guard Kit
Installation Manual
Author: Clay Warner
Release Date: 11/09/2023
Approvals:E. Hazen
Document Revisions
Rev
Date
Author
Description
01
11/09/2023
C. Warner
Issued for Release
Verus Engineering
[e-mail]

E. Hazen
2 3/6/2016
Author: C. Warner
Date: 11/09/2023
Recipients: Public
ENGINEERING | NORTH AMERICA
REVISION: R01
Verus Engineering
[e-mail]
Hood Louver Rain Guard –Install Manual
CONTENTS
1. Introduction ....................................................................................................................................... <3>
1.1. Overview .................................................................................................................................... <3>
1.2. Difficulty..................................................................................................................................... <3>
1.3. Time Required............................................................................................................................ <3>
1.4. Tools Needed ............................................................................................................................. <3>
1.5. Rain Guard Kit Components ...................................................................................................... <3>
2. Rain Guard Kit Install......................................................................................................................<4-5>

E. Hazen
3 3/6/2016
Author: C. Warner
Date: 11/09/2023
Recipients: Public
ENGINEERING | NORTH AMERICA
REVISION: R01
Verus Engineering
[e-mail]
Hood Louver Rain Guard –Install Manual
1.1. Overview: Detailed instructions on installing the Verus Engineering Hood Louver Rain Guard
Kit.
1.2. Difficulty: Easy
1.3. Time Required: 15 minutes
1.4. Tools Needed:
•Ratchet
•9mm socket
1.5. Assembly Components
1.5.1. Rain Guard Kit
1.5.1.1. (1) Left-Hand Rain Guard
1.5.1.2. (1) Right-Hand Rain Guard
1.5.2. Hardware Bag
1.5.2.1.1. (10 to 20) 8-32 serrated nut, stainless (Depends on which rain guard kit you are
installing)

E. Hazen
4 3/6/2016
Author: C. Warner
Date: 11/09/2023
Recipients: Public
ENGINEERING | NORTH AMERICA
REVISION: R01
Verus Engineering
[e-mail]
Hood Louver Rain Guard –Install Manual
2. Hood Louver Rain Guard Kit Installation
2.1. We are not responsible for damage to you or your vehicle by following this manual and
installing Verus Engineering products.
2.2. We will begin this install by gaining access to the underside of your hood where the hood
louvers have been previously installed.
2.3. Determine the left and right-side rain guard and start by holding the rain guard up to the pem
studs that come down from the hood louver. Notice the rain guard installs below the serrated
nuts that hold the hood louver to the hood.
2.4. Install all necessary nuts hand tight as shown below.

E. Hazen
5 3/6/2016
Author: C. Warner
Date: 11/09/2023
Recipients: Public
ENGINEERING | NORTH AMERICA
REVISION: R01
Verus Engineering
[e-mail]
Hood Louver Rain Guard –Install Manual
2.5. Once the nuts are installed hand-tight, you can now snug them up with an 1/8 turn of your
ratchet. These nuts are serrated and will resist backing off. If you over torque these nuts, it is
possible the pem studs can be pulled away from the hood louver itself.
2.6. Congratulations on installing your Hood Louver Rain Guard Kit! Now you can enjoy a much
cleaner engine bay and peace of mind. Please email us at [e-mail] with
any concerns, comments, or feedback.