Introduction
The information in this manual outlines the recommended “Best Practices” for the installation of Vicon’s
Kollector series of PC-based digital video recorders. Kollector recorders are Windows-based PC products
and should be treated as expensive computer hardware.
Although this document is a guideline, failure to follow these recommendations, especially for environmental
conditions, can cause unnecessary and costly problems. It is in the customer’s best interest to adhere to all
points in this guide during the initial stages of system design and installation.
If the installation area does not properly support these requirements, failure of the unit is likely to occur due to
excessive heat, poor power conditions and poor cabling.
Kollector recorders come in many different configurations that support different levels of software capability
and performance. However, the installation requirements for all Kollector units are the same due to the
commonality of the hardware platform across all models. These recorders will be referred to as Kollector
throughout this manual. For detailed information on the Kollector recorders, refer to the following family of
documentation:
Kollector Elite: XX112
Kollector Pro: XX128
Kollector complies with UL standard 2044, CSA safety standard C22.2, No. 1 and meets requirements for an
FCC Class A computing device.
NOTE: Read all instructions before beginning any installation.
Warning: Please Note the following points prior to reading this document.
1. This is sensitive computer equipment. DO NOT stack, drop or otherwise mishandle. Failure to properly
handle this unit will result in unit damage.
2. Vicon strongly requires the use of an Uninterruptible Power Supply (UPS) in the electrical power service.
Failure to comply voids the warranty.
3. This system should only be installed by a qualified technician using common hand tools and approved
materials in accordance with national, state and local wiring codes.
This system should only be setup by a qualified technician with a basic understanding of the Windows
operating system and intermediate networking skills.
4. This system requires proper shutdown to ensure system integrity. Failure to properly shutdown the
recorder can result in data loss and lengthy file rebuilding upon next boot.
5. Removal of the top cover, or any other attempted unit disassembly, should only be attempted by a
qualified technician with the express permission of Vicon Technical Support.
6. This system relies on the building’s electrical service for short-circuit (over current) protection. Ensure that
a fuse or circuit breaker is present in the service at a minimum of 120 VAC, 15 A (230 VAC, 10 A
international).
7. It is not recommended to operate this system in a dusty environment. Failure to periodically inspect and
clean the front panel air filter may result in shutdown of the unit and eventual permanent failure requiring
factory repair.
2 •Introduction XX112-70-00 Rev 904 Kollector Pre-Installation Requirements
