Victron energy SHS 200 User manual

www.victronenergy.com
Quick Installation Guide SHS 200 Battery Box
Included
Not Included
Fix the proles to the bottom plate.
Use supplied M4 screws.
Slide the front and back plate through the
proles gap.
Snap-in four Corner-Caps on top of each screw
head. The cap should click once it’s properly
attached.
Carefully, lift the battery and slide it inside the
enclosure from the top.
J
SHS-200
HI
Battery
K
PV
L
(x8) Self-Tap
Screw for metal
Plastic Cap (x8) Corner
Cap
(x4) Screw
back cover
(x3) Screw
M
(x4) Screw
(x2) Side
Plate
(x2) Front/
Back Plate
Top Plate
(x4) Profile
H
H
H
Slide in the lateral plates through the prole gaps.
AA
E
C
D
B
F
A
A
A
A
E
G
K
M
D
G
G
F
K
A, C, E, H
A, C, E
H, G
A, C, E
H, G
B
B
J
I
A, E, H
C
C
G
D
Fix the SHS-200 top-plate of the
battery box. Use the 4 screws supplied
together with the SHS wall-montures.
Fix the plastic cap to the top
plate. Make sure the battery
cable is going through the
opening as shown on the
picture.

RISK OF IRREVERSIBLE DAMAGE IF
THE BATTERY IS WRONGLY WIRED
REVERSE POLARITY IS NOT
COVERED BY WARRANTY
Before closing the box, connect the battery cables to the battery terminals.
Respect cable polarity as described on the following graph. For multiple batteries, connect them in
parallel array, to maintain 12v operating voltage.
*Parallel Battery Configuration
Before closing the battery box make sure the
SHS-200 has turned ON.
Fix the top plate by screwing four screws
inside the proles. Snap-in four corner-caps
on top of each screw head.
Optional: To add extra protection against
tampering, place 2 warranty void labels
connecting side-plate with top-plate.
Now, you are ready to connect the solar panel
and appliances to the SHS-200.
www.victronenergy.com
Quick Installation Guide SHS 200 Battery Box
G
H
VOID
B, F, I, J