Vista 1447 User manual

INSTALLATION INSTRUCTIONS Bollards and Beacons
1447
TOOLS REQUIRED FOR
INSTALLATION:
●Wire strippers
●Flat head screwdriver
●Shovel
●Silicone grease
WARNING: Luminaire must be installed and grounded in accordance with the National Electrical Code (NEC)
and local codes. For portable stake or surface mount using a cord and plug, the luminaire must be plugged into
a receptacle protected by a ground fault circuit interrupter (GFI). Failure to do so may result in serious injury and/
or damage to the luminaire.
MAINTENANCE: To assure proper operation and efciency and to prevent luminaire overheating, lens must be
kept clean and free of dirt, dust, leaves, trash and mineral deposits from water. A regular schedule maintenance
program is recommended.
SAFETY WARNING: Luminaire can become very hot depending on the lamp wattage used. Lens and housing
around the lamp can become hot enough to blister hands. Particular care should be taken not to locate
luminaires where small children can reach them if high wattage lamps are used.
NOTE: Always use UL recognized wire connectors for connections.
NOTE: Save these instructions for future reference.
IN GROUND LUMINAIRE IS UL LISTED FOR ABOVE GRADE INSTALLATION ONLY.
LUMINAIRE MOUNTING:
NOTE: Your Vista 12 volt Bollard is provided with 12” extra post length to facilitate an in ground installation. However, for a
permanent and secure installation a concrete footing support for the bollard post is recommended.
1. Make sure electrical supply is off at circuit breaker before starting luminaire installation or servicing luminaire.
2. Using standard masonry procedures, support bollard post in selected location.
3. Install conduit.
4. Pull supply wires (line in) through conduit into bollard.
5. Attach luminaire leads to line in leads observing polarity, black to black, white to white and green to ground using silicone
lled safety connectors (provided).
6. Pour concrete at least 2” thick.
7. Supply power to the luminaire and check for proper operation.
1625 Surveyor Avenue • Simi Valley, CA 93063 • [phone] • (800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com
120V SERIES
Lamp Information
Cat No Lamp Type Max Watts
1447 PL
Compact Fluorescent
22 W
Shade
Lens
Concrete
Conduit (by others)
Cover Screw
Soil
Bollard Post

IMPORTANT SAFETY INSTRUCTIONS
THE LIGHTED LAMP IS HOT!!
WARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO
PERSONS:
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamps get hot quickly! Contact only switch/plug when turning on.
3. Do not touch hot lens, guard or enclosure.
4. Keep lamp away from material that may burn.
5. Do not touch the lamp at any time. Use a soft cloth. Oil from the skin may
damage lamp.
6. Do not operate luminaire tting with a missing or damaged cover.
SAVE THESE INSTRUCTIONS
LAMP INSTALLATION/REPLACEMENT:
CAUTION: Do not exceed maximum wattage marked on luminaire label.
1. To prevent electrical shock, disconnect from electrical supply before service.
2. Loosen the cover screws and remove cover.
3. Remove lens and gasket.
4. Replace lamp with correct wattage and type marked on xture label.
NOTE: DO NOT touch lamp with bare hands. Always use soft cloth or the plastic wrapping (if available) from the lamp to
handle the lamp.
5. Re-install gasket, lens and cover and tighten the cover screws evenly.
1625 Surveyor Avenue • Simi Valley, CA 93063 • [phone] • (800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com