RH ARMAGNAC User manual

ARMAGNAC TRIPOD FLOOR LAMP
PARTS ENCLOSED
(A) Finial (1)
(B) Harp (1)
(C) Harp Saddle (1)
(D) Bulb (1)
(E) Lamp Pole (1)
(F) Side Leg (1)
(G) Bracket (1)
(H) Thumbscrews (2)
(I) Adjustment Key (1)

ARMAGNAC TRIPOD FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION BY A LICENSED ELECTRICIAN IS STRONGLY
RECOMMENDED.
This xture has been rated for one (1) 100-Watt maximum Type A
standard lightbulb (not included), one (1) 23-Watt compact uorescent
lightbulb (not included) or one (1) 9-Watt SBLED lightbulb (included).
To avoid the risk of re, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the lightbulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY
VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION
SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE FUSE
BOX OR CIRCUIT BREAKER PANEL.
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Remove Thumbscrews (H) from Bracket (G).
3. Insert the top end of Side Leg (F) into Bracket (G), then tighten by
inserting Thumbscrews (H).
4. Insert Bulb (D) into the threaded socket.
5. Insert Harp (B) into Harp Saddle (C).
6. Unscrew Finial (A) from Harp (B). Place the shade (not included)
over Harp (B).
7. Attach Finial (A) and tighten to secure the shade.
8. Plug into proper electrical outlet and test xture.
9. Assembly is complete.
TO ADJUSTLoosen Adjustment Key (I) in a counter-clockwise
direction.
10. Adjust the lamp by pulling or pushing Lamp Pole (E) to the desired
height.
11. Tighten Adjustment Key (I) in a clockwise direction to secure Lamp
Pole (E) in place.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the fixture. Wipe clean with a soft,
dry cloth.