2 3
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
PACKAGE CONTENTS
TOOLS NEEDED
Scissors
ASSEMBLY STEPS
STEP 2
WARNING!
Phillips
Screwdriver
A (x1)
Desktop
STEP 1
Carefully remove the desktop (A) from the
packaging and cut zipties on either side of the
desk frame as shown in the diagram.
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
37.5lbs
17.01kg
STEP 3
Attach feet (B) to bottom of desk frame using
screws (C) and allen wrench (D). Remove adhe-
sive backing from rubber feet (G) and stick to
frame as shown in diagram.
B (x2)
Feet
C (x6)
Screw
D(x1)
4mm Allen
Wrench
E (x1)
Cable Clip
F (x2)
Cable Tie
G(x4)
Rubber Feet
H(x1)
Keyboard Tray
Squeeze handles on both sides of desk (A)
and gently li up to raise. Mount keyboard
tray (H) onto pre-installed screws in desk
frame, and use allen wrench (D) to tighten.
Remove adhesive backing from cable
management clip (E) and apply under desk
top where desired. Use cable ties (F) to
manage cables.
Raise desktop
slowly to keep
items stable.
Keep monitor and
laptop base fully on
the desktop.
Leave enough slack
in cable to allow for
full range of vertical
motion (15” / 38 cm).
Follow the cable
routing instructions to
avoid the potential to
pinch cables.
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
BG
C
D
B
D
H
E
