2 3
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
TOOLS NEEDED
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
ASSEMBLY STEPS
STEP 2
WARNING!
Phillips
Screwdriver
STEP 1
Carefully remove the desktop (A) from the packaging and ip the desktop (A) onto a at surface. Attach
the extended feet (B) to the frame using screws (D).
33lbs
14.97kg
STEP 4
Press the handles on each side and li the
desktop (A).
Place laptop, monitor, and other items on desk
surface. Attach cable clip (F) to desk to manage
keyboard and mouse cables. Manage cables
using cable zipties (G).
STEP 3
STEP 5
Mount brackets (H) to keyboard tray (C) using
screws (D). Mount keyboard tray (C) to desk
using screws (E).
If locks are not releasing properly to change
desk height, adjust the position of the black
tube containing the steel release cable. Turn
the nuts at the end of the tube just behind
the handle as shown, moving the tube away
from the handle until the cable once again has
proper tension, then tighten the nuts.
PACKAGE CONTENTS
A (x1)
Desktop
B (x2)
Extended Feet
C (x1)
Keyboard
Tray
D(x10)
Screw
E (x6)
Screw
F (x1)
Cable Clip
G(x2)
Ziptie
H(x2)
Bracket
D
B
B
D
C
H
E
G
F
Raise desktop
slowly to keep
items stable.
Keep monitor and
laptop base fully on
the desktop.
Leave enough slack
in cable to allow for
full range of vertical
motion (15” / 38 cm).
Follow the cable
routing instructions to
avoid the potential to
pinch cables.
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
