Vivo STAND-SIT1K User manual

1
-    
Instruction Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-  
Scan the QR code with your mobile device or follow the link to
helpful videos and specifications related to this product.
 
phillips screwdriver, electric drill
 
 !"
! #
#  #"
$ %
 "
% &
' !"
%
!  "
!($ %(
#  '"
#  !"
% )
*
 # ' $
!
+ "
,'--
+#  "
,!--
+'  "
,%--
.  '"
& !)
.#  '"
$ %)
%
+!  %"
/ 0
  '"
$ #%
- -102233 (-202 

2
 
For concrete walls, use the
wall mount (A3) to mark the
mounting location. Using a
8mm bit, drill approximately
2.6” into wall. Use concrete
anchors (F1) and bolts (F2) to
secure the wall mount (A3) in
place.
-45 0
0  60 
Find the stud in wall
where stand will be
attached. Use the wall
mount (A3) to mark
mounting location. Using
a 3mm bit, drill
approximately 1.2” into
stud. Using screws (F2),
secure the wall mount
(A3) in place.
  
0  60 
0 '
Using bolts (C2) and nuts (C3), attach keyboard tray (A2) to
keyboard bracket (A6) as shown in diagram.
0 #
Use allen key (E2) to
attach bolt
(C1) to keyboard
bracket (A6) as shown
(do not tighten).

3
Attach mount fitting (A ) to arm (A1) using bolts (B2) and washer
(C4). Use washer with top bolt inserted through slot. Tighten the
bolts (B2) using the allen key (E2).
0 !
Attach keyboard tray assembly (A6) to arm (A1). Use the allen key
(E2) to tighten the bolt on the bracket.
0 %
Attach the arm (A1) to the extension (A4) using the bolt (D1) and
cap (D2). Adjust using the allen key (E1). Secure to the wall mount
(A3) using the bolt (D1) and cap (D2).
NOTE: Turn clockwise to reduce tension for lighter keyboards and
counter-clockwise to increase tension for heavier keyboards.

4
If you do not understand these directions, or if you have
any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are
no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual.
We cannot be liable for damage or injury caused by
incorrect assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please
contact us. We are happy to replace parts to ensure you
have a fully functional product.
75 
  
Last updated: 4/30/2018
0 $
Mount monitor to arm (A7) using bolts (B1). Attach arm (A7) to wall
mount (A3).
Mount monitor to
mechanical spring arm
using M4x12 screws (B1).
Adjust to proper
tension.
Attach velcro pads (E4)
to keyboard tray.
Use allen key (E3) to adjust
the tension of the arm (A7).
Adjust keyboard tray minimum tilt
angle by turning the set screw under
the joint counter-clockwise with the
Allen key (E1).