Walker Edison P60CMP User manual

Item #: P60CMP
Assembly Instructions
For our most current instructions, to request missing, lost or broken parts, or for any other Customer
Service issues, please visit our website at www.walkeredison.com or call us at 877-207-5906.
Revised 11/2010

General Assembly Guidelines
I. Ensure that all parts and hardware are available before beginning assembly.
II. Follow each step carefully to ensure the proper assembly of this product.
III. Two people are recommended for ease in the assembly of this product.
IV. The four main types of hardware used to assemble this product are: wood dowels,
cam bolts and locks, bolts and screws.
V. The provided glue is to secure wood dowels in place. When first inserting dowels,
locate the appropriate hole for the dowel, place a small amount of glue in the hole
and insert the dowel. Wipe away excess glue immediately.
In future assembly steps when dowels are necessary to attach assembly parts
together, place a small amount of glue on the end of the dowel before attaching
parts together. Wipe away excess glue immediately.
VI. A Phillips head screwdriver is required for the assembly of this product.
VII. Power tools should not be used to assemble this product.
P.2

Parts List

Hardware List
Short cam bolt
Short wood dowel
Large bolt
Wrench
Long cam bolt
Long wood dowel
Handle
Small bolt
Screw
Sticker
Glue tube
Large cam lock
Small cam lock

Screw short cam bolts (C) into stand top (1).
Attach feet (12) and stand support (11) to stand base (3) using large bolts (E) and wrench (F).

Screw short cam bolts (C) into stand base (3).
Insert short dowels (D) into panels (8) on appropriate sides.

Insert short dowels (D) into panels (4,5,6,7) on appropriate sides.
Insert short dowels (D) into back panels (9,10).

Attach panels (5,6,7,8) to stand base (3) using cam bolts and dowels as guides. Note that panels (8) are not
attached to panels (6,7), but that all panels should align when attached to stand base (3). Secure panels
(6,7,8) to stand base (3) by inserting large cam locks (A) into panels (6,7,8) and tightening with a screwdriver.
Carefully slide back panel (10) into place at the back of the stand assembly. Use cam bolts and dowels as
guides.

Insert cam locks (A) into back panel (10) and tighten with a screwdriver. Insert long dowels (H) into panels
(6,7,8) and back panel (10).
Carefully slide middle panel (2) into place on stand assembly. Use dowels as guides.
7

Insert long cam bolts (G) into middle panel (2). Insert large cam locks (A) into panels (6,8) and back panel
(10). Tighten with a screwdriver to secure middle panel (2).
On opposite end of stand assembly, insert long cam bolts (G) into middle panel (2). Insert large cam locks (A)
into panels (7,8) and tighten with a screwdriver.
A
A
A
A
10