Walker Edison V42Y78B User manual

,V42Y78
Wrench 1
4
D
ARubber Washer
P
20” Rod

Important: Make sure all parts are available for assembly
Follow instruction steps very carefully.
Step 1: Lay glass “L” upside down on a soft surface.
Screw rods “D” onto all four outside corner plates.
Screw rods “F” into all four inside plates.
Be sure and tighten completely.
Step 2: Place cylinders “A” onto the four outside rods “D”.
Place cylinders “C” onto the four inside rods “F”.
Step 3: Place small rings “H” onto all four cylinders “C”.
Be sure to place flat side of rings facing glass.
Place middle glass “M” on all four inside rods “F”.
Place small rings “H” onto the four inside rods “F”.
Place cylinders “C” onto all four inside rods “F”.
Place small rings “H” onto all four inside cylinders “C”.
Place middle glass “M” on all four rods “F”.
Place rubber washers “I” on all four rods “F”.
Place washers “J” on all four rubber washers “I”.
Screw nuts “K” on all four rods “F”.
Be sure and tighten completely.
Step 4: Place rings “G” on all four outside rods “D”.
Place bottom glass “N” on all four outside rods “D”.
Place rings “G” on all four outside rods “D”.
Screw cylinders “B” on outside rods “D”.
Place feet “O” on all four corner cylinders “B”.
Step 5: Attach Cable Management “P” to top glass “L” using
Rods and Nuts “Q”.
Step 6: Turn upright very slowly.
**Note: Ensure that the holes in each pane of glass are centered around the
screw before tightening down.
For our most up to date assembly instructions or to request
missing, lost, or broken parts, or for any other customer service
issue, please visit our website at www.walkeredison.com or call
us at 877-207-5906 .
Assembly Instructions
V42Y78, V42Y78B, V42Y78CB