Waring 6001C IB User manual

6001C IB
JUICE EXTRACTOR
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.

2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be taken, including the following:
1. READ ALL INSTRUCTIONS.
2. Unplug from outlet when not in use, before putting on or
taking off parts.
3. To protect against risk of electrical shock, do not put
motor housing in water or other liquids.
4. This appliance is not suitable for use by children.
5. Avoid contact with moving parts.
6. Do not operate any appliance with a damaged cord or plug
or after the appliance malfunctions or has been dropped
or damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or
mechanical adjustment.
7. The use of any attachments not recommended or sold by the
manufacturer is not permitted. No other cover or collector bowl
should be used. Should this happen, accidents could occur.
All warranty claims would be void in this case.
8. Do not let cord hang over edge of table or counter, or touch
hot surfaces.
9. Always make sure juicer lid is secure beneath springs before
motor is turned on. Do not loosen lid while juice extractor
is in operation.
10. Be sure to turn switch to OFF position after each use of your
juice extractor. Make sure the motor stops completely before
disassembling.
11. Do not put your ngers or other objects into the juice extractor
opening while it is in operation. If food becomes lodged in the
opening, use food pusher or another piece of fruit or vegetable
to push it down.
12. Please keep these operating instructions in a suitable and
safe place.
SAVE THESE INSTRUCTIONS
APPROVED FOR COMMERCIAL USE

3
ASSEMBLY-DISASSEMBLY INSTRUCTIONS
IMPORTANT: Juice extractor should be unplugged from outlet when
disassembling.
ASSEMBLING (SEE FIG. 1):
1. To assemble juicing assembly,
place bowl on base housing and
place spout facing front between
the two raised projections.
2. Place basket inside the bowl
over the hex nut. Be certain
basket sits at.
3. Place cutter blade inside basket
with teeth up.
4. Tighten spring clutch nger-tight
or snug.
5. Your juicer includes a 20 pack of
lters. Using the lters is optional. If
using the lter, insert the lter inside
the basket and open the lter so that it covers the
inside perimeter of the basket. The lters can be purchased
as a 200 pack accessory with model number CAC66.
Contact your local Waring dealer for more information or visit
www.waringcommercialproducts.com to locate a dealer.
6. Place cover on bowl with feeder chute to right rear and turn it
counterclockwise to secure
beneath spring clips.
7. The juice extractor will not operate until the cover is properly
assembled in place.
DISASSEMBLING (SEE FIG. 1):
1. With juice extractor facing you (spout front) put your hands
on both sides of the cover. Using the sidearms, turn cover
clockwise. This will disengage the cover from the spring clips
and allow you to lift off the cover.
2. Looking into juice extractor, remove spring clutch by unscrewing
counterclockwise.
3. Lift out cutter blade.
4. Lift out strainer basket.
5. Lift off bowl.
Plunger
Feeder Chute
Cover
Spring Clutch
Cutter Blade
Strainer Basket
Bowl
Spout
Spring Clip
Sidearms
Hex Nut
Motor Base
Housing
FIG. 1
Juicing Assembly

4
OPERATION
1. Be sure the juice extractor is fully assembled, making sure that
the spout points correctly to the front. When placing the cover
on top of the machine, make sure the feeder chute is to the rear
of the machine.
2. For best results fruits and vegetables should always be fresh.
Cut fruit and/or vegetables as needed to t through the chute.
After cutting them into smaller sections, fruits and vegetables
should be pushed through the cover opening downwards
onto the blade with the plunger. The juice will be ejected
through the basket into the collector bowl. When feeding hard
fruit or vegetables through the chute, increase pressure on the
plunger slowly as needed. Please be careful not to overload the
appliance.
NOTE: If the appliance starts to vibrate, stop juicing, turn off
the appliance, wait for motor to stop and then remove pulp
from basket.
3. This juice extractor comes standard with a safety device to
protect you from personal injury during operation of the unit.
Therefore, it must be fully and properly assembled to operate.
4. IMPORTANT NOTE: For your safety and protection, this juice
extractor is equipped with a thermal protector. Should your
juice extractor overheat, the motor will automatically shut off.
To restart, follow these steps: Move the toggle switch to the OFF
position. Unplug juice extractor from electrical outlet. Let motor
cool down for approximately 5–10 minutes. Once the motor has
cooled down, plug unit into electrical outlet. Move toggle switch
to ON position to continue juicing.
CLEANING AND SANITIZING INSTRUCTIONS
ALL COMPONENTS MUST BE CLEANED AND DRIED AFTER
EACH USE OF THE JUICER ACCORDING TO THE FOLLOWING
INSTRUCTIONS. FAILURE TO DO SO MAY ALLOW RESIDUE OF
PROCESSED MATERIAL TO COLLECT ON THE INTERNAL SEALS
OF THE BLADE ASSEMBLY, RENDERING THEM INEFFECTIVE.
• Wash, rinse, sanitize and dry juicing assembly prior to initial
use and whenever it will not be used again within a period
of 1 hour.
• Wash and rinse juicing assembly after each use.

5
• Clean and sanitize motor base prior to initial use and
after each use.
• Washing solutions based on non-sudsing detergents and
chlorine-based sanitizing solutions having a minimum chlorine
concentration of 100 PPM are recommended.
The following washing, rinsing, and sanitizing solutions, or their
equivalents, may be used.
To Sanitize and Dry Container:
1. Wipe down exterior of juicing assembly with a soft cloth or
sponge dampened with sanitizing solution.
2. Submerge removable components in sanitizing solution
for two (2) minutes.
3. Do not rinse juicing assembly after sanitizing is completed.
4. Allow parts to air-dry.
To Clean and Sanitize Motor Base:
1. UNPLUG POWER CORD. Wipe down exterior surfaces of motor
base with soft cloths or sponges dampened with washing
solution, rinse water, and sanitizing solution. Prevent liquid from
running into motor base by wringing all excess moisture from
cloths or sponges before using them.
DO NOT IMMERSE MOTOR BASE IN WASHING SOLUTION,
RINSE WATER OR SANITIZING SOLUTION.
2. Allow motor base to air-dry before using.
Any other servicing should be performed by an authorized service
representative.
SOLUTION PRODUCT DILUTION IN WATER TEMPERATURE
WASHING DIVERSEY®WYANDOTTE 4 TABLESPOON HOT 115°F (46°C)
DIVERSOL®BX/A OR CX/A / GALLON
RINSING PLAIN WATER WARM 95°F (35°C)
SANITIZING CLOROX®1 TABLESPOON / GALLON COLD 50°F – 70°F
INSTITUTIONAL BLEACH (10°C– 21°C)

6
SERVICE
Refer to the list of Authorized Service Centers enclosed with your
Waring®Commercial Blender for the name of the nearest Service
Center, or write to:
Waring Factory Service Center
P.O. Box 3201
314 Ella T. Grasso Avenue
Torrington, CT 06790
1-[phone]
Ship juicers for repair to the above address or to an Authorized
Service Center. Do not ship to a Waring Sales Ofce.
Note: If your application involves the processing of biologically active
material, we request that any items returned for service be sterilized
before being shipped. Such items must be clearly identied as having
been sterilized, both by a tag on the item itself and by a statement in
the accompanying correspondence. Waring will not accept delivery
of any return unless it is so identied. Replacement parts for your
out-of-warranty repairs are obtainable at the address below.
Limited One Year Warranty
Waring warrants every new Waring®Commercial Juicer to be free
from defects in material and workmanship for a period of one year
from the date of purchase when used with foodstuffs, nonabrasive
liquids (other than detergents) and nonabrasive semi-liquids,
providing it has not been subject to loads in excess of the indicated
rating. Under this warranty, Waring will repair or replace any part
that, upon our examination, is defective in materials or workmanship,
provided the product is delivered prepaid to the Waring Service
Center at: 314 Ella T. Grasso Ave., Torrington, CT 06790, or any
Factory Approved Service Center. This warranty does not: a) apply
to any product that has become worn, defective, damaged or
broken due to misuse or due to repairs or servicing by other than
the Waring Service Center or a Factory Approved Service Center,
or due to abuse, misuse, overloading or tampering; or b) cover
incidental or consequential damages of any kind. The one year
warranty is applicable only to appliances used in the United States
or Canada; this supersedes all other express product warranty or
warranty statements. For Waring products sold outside of the U.S.
and Canada, the warranty is the responsibility of the local importer or
distributor. This warranty may vary according to local regulations.
Warning: This warranty is void if appliance is used on Direct Current (DC).

7
NOTES

Trademarks or service marks of third parties used herein are
the trademarks or service marks of their respective owners.
©2015 Waring Commercial
314 Ella T. Grasso Ave.
Torrington, CT 06790
www.waringcommercialproducts.com
6001C IB
14WC007995
Part Number: 015461
RV06 1409