Warmlite WL41001 User manual

www.warmlite.co
2000W
CONVECTION HEATER
MODEL WL41001
YOUR SAFETY &
INSTRUCTION MANUAL
PLEASE READ CAREFULLY
This product is only suitable for well insulated spaces or occasional use.

2
CUSTOMER SUPPORT TEAM: [phone]
TECHNICAL DATA
Description: Convection Heater
Model: WL41001
Rated Voltage: 220 - 240V
Frequency: ~ 50Hz
Power consumption: 2000W
DOCUMENTATION
We declare that this product conforms to the following product legislation in accordance with the
following directive(s):
2014/30/EU Electromagnetic Compatibility Directive.
2014/35/EU Low Voltage Directive.
2011/65/EU Restriction of Hazardous Substances Directive.
RK Wholesale LTD Quality Assurance, United Kingdom
WARRANTY
This product is guaranteed for 12 months from the date of original purchase. If any defect arises due
to faulty materials of workmanship, the faulty products must be returned to the place of purchase.
Refund or replacement is at the discretion of the retailer.
The following conditions apply:
• The product must be returned to the retailer with proof of purchase.
• The product must be installed and used in accordance with the instructions contained in this
instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• RK Wholesale LTD has limited liability for incidental or consequential loss or damage.
• This guarantee is only Valid in the UK and Eire Only.
An extended warranty is available for this appliance.
See back page for details.

3
www.warmlite.co
WIRING SAFETY FOR UK USE ONLY
IMPORTANT
As the colours in the
mains lead of this
appliance may not
correspond with the
coloured markings
identifying the terminals
in your plug, please
proceed as follows:
The wires in the mains lead are coloured in
accordance with the following code:
Blue neutral [N] Brown live [L]
Green/Yellow [EARTH]
Plug Fitting Details (Where Applicable).
The wire coloured blue is the neutral and must
be connected to the terminal marked [N] or
coloured black.
The wire coloured brown is the live wire and
must be connected to the terminal marked [L] or
coloured red.
The wire coloured green/yellow must be
connected to the terminal marked with the letter
[E] or marked .
On no account must either the brown or the blue
wire be connected to the [EARTH] terminal .
Always ensure that the cord grip is fastened
correctly.
The plug must be tted with a fuse of the same
rating already tted and conforming to BS 1362
and be ASTA approved.
If in doubt consult a qualied electrician who will
be pleased to do this for you.
Non-Rewireable Mains Plug
If your appliance is supplied with a non-
rewireable plug tted to the mains lead and
should the fuse need replacing, you must use an
ASTA approved one (conforming to BS 1362 of
the same rating).
If in doubt, consult a qualied electrician who will
be pleased to do this for you.
If you need to remove the plug – disconnect
it from the mains – and then cut it o of the
mains lead and immediately dispose of it in a
safe manner. Never attempt to reuse the plug or
insert it into a socket outlet as there is a danger
of an electric shock.
WARNING:
This Appliance MUST be Earthed
FUSE

4
CUSTOMER SUPPORT TEAM: [phone]
PRODUCT SAFETY
When using any electrical appliance, basic safety precautions should
always be followed including the following:
• Check that the voltage of the
main circuit corresponds with
the rating of the appliance
before operating.
• Please ensure that the appliance
is used on a stable, level, and
heat resistant surface.
• DO NOT immerse cords, plugs
or any part of the appliance in
water or any other liquid.
• DO NOT leave the appliance
unattended while it is operating.
• Close supervision is necessary
when any appliance is used by
or near children or pets.
• This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge
if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• Children shall not play with the
appliance.
• Cleaning and user maintenance
shall not be made by children
without supervision.
• Switch o at the wall socket
then remove the plug from
the socket when not in use or
before cleaning.
• If the supply cord or appliance
is damaged, stop using the
appliance immediately and seek
advice from the manufacturer
or its service agent or a similarly
qualied person.
• DO NOT let the cord hang over
the edge of a table or counter or
let it come into contact with any
hot surfaces.
• The use of accessory
attachments is not
recommended by the appliance
manufacturer apart from those
supplied with this product. DO
NOT use extension cords with
the appliance.
• DO NOT pull the plug out by the
cord as this may damage the
plug and/or the cable.
• DO NOT use this product for
anything other than its intended
use.
• This appliance is for household
use only.
• DO NOT carry the appliance by
the power cord.
• DO NOT use the appliance
outdoors.

5
www.warmlite.co
• Always ensure that the heater is
placed on a rm level surface.
Ensure that the heater is not
positioned close to curtains,
furniture or any combustible
materials as this could create a
re hazard.
• Allow a 50cm safe area around
the heater on the top and sides
and a 120cm safe area at the
front of the appliance.
• The heater must not be located
immediately below a mains
socket outlet.
• DO NOT cover the heater as this
may lead to a re risk.
• DO NOT obstruct any of the
openings of the heater.
• DO NOT insert any object
through any openings on the
heater.
• Check from time to time for
accumulated dust.
• DO NOT use the heater in
areas where ammable liquids
are stored or where ammable
fumes may be present.
• DO NOT operate the heater on a
timer, or leave on overnight.
• When not being used, please
unplug the heater from the
mains socket.
• Keep the mains lead away from
the hot body of the heater and
ensure that it is not pulled tight
between the socket and the
heater.
• DO NOT use the heater in the
immediate surroundings of a
bath, a shower, a swimming
pool or similar indoor locations
and DO NOT touch hot
surfaces.
• Always unplug the heater and
allow it to cool before moving it
from one location to another.
• DO NOT attempt to dismantle
or repair any part of the heater.
This should only be done by a
qualied service agent.
• DO NOT attempt to dismantle or
repair any part of the heater.
This should only be done by a
qualied service agent.
• In the unlikely event the
appliance develops a fault,
stop using it immediately and
seek advice from the Customer
Support Team.
HIGH VOLTAGE HOT SURFACE DO NOT COVER

6
CUSTOMER SUPPORT TEAM: [phone]
2
3
4
5
1
6
WHAT’S IN THE BOX
Instruction Manual
Convection Heater
2 Feet
4 Self Tapping Screws
1. Output Vents
2. Handles
3. Heat Control Switches
4. Thermostat Control knob
5. Air vents
6. Feet
BEFORE YOUR FIRST USE:
1. Remove your appliance from the packaging.
2. Assemble your appliance.
3. Locate your appliance in accordance with the safety instructions.
4. Plug the appliance into the mains supply.
5. Your appliance is now ready for normal use.
Dispose of the packaging in a responsible manner.

7
www.warmlite.co
ASSEMBLY
Before using the heater, the
feet (supplied separately in
the carton), must be tted
to the unit. These are to
be attached to the base
of the heater using the 4 self-tapping screws
provided, taking care to ensure that they are
located correctly in the bottom ends of the
heater side mouldings.
USING YOUR APPLIANCE
NOTE: It is normal for the heater to emit some
smell and fumes when it is turned on for the
rst time or has been turned on after a long
period of non-use. This will disappear after the
heater has been on for a short while.
1. Choose a suitable location for the heater,
taking into account the safety instructions.
2. Insert the plug of the heater into a suitable
socket.
3. Turn the thermostat knob fully in a
clockwise direction to the maximum
setting.
4. There are 3 heat settings, 750W, 1250W
& 2000W. To use your rst heat setting,
select the switch under the 750W mark.
To use the second heat setting only turn
on the switch under the 1250W mark. To
use your third setting of 2000W, press
both switches at the same time. The
power indicator light will light up once the
switch is in the on position.
5. When the desired room temperature
has been reached, the thermostat knob
should be turned slowly anti-clockwise
until the thermostat is heard to click o
and the lights on the element switches are
seen to go out.
6. After this the heater will keep the air
temperature in the room at the set
temperature by switching on and o
automatically.
WALL MOUNTING THE HEATER
Caution: The heater must be installed at
least 0.5m above the oor and 1.0m under
the ceiling. The feet must be removed before
mounting the appliance on the wall
1. Measure the distance between the two
slots situated at the back of the appliance.
(g.1)
2. Drill two holes at the same distance in
the wall and insert a plug into each drilled
hole. Place the brackets facing the holes
and attach them into position using the
screws supplied. (g.2)
3. Before attaching the appliance on to the
brackets, attach the two other brackets
underneath the appliance. (g.3)
FIG. 2FIG. 1 FIG. 3

8
CUSTOMER SUPPORT TEAM: [phone]
4. Attach the appliance on the wall. To do
so, hold it so the slots are facing the
brackets; insert the appliance halfway
onto the brackets until the appliance
can go down into the grooves of the
brackets.
5. As soon as the appliance is positioned
correctly, take a pencil and mark a dot
in the hole of each bracket situated
underneath the appliance.
6. Remove the appliance from the wall.
7. Drill a hole in the wall on each marked dot
and insert a plug into each hole.
8. Attach the appliance back on the wall as
indicated in point 4, insert screws through
the brackets underneath the appliance
and tighten without forcing.
CLEANING AND CARE
• Before cleaning always switch o the
heater and remove the plug from the
electrical socket.
• Ensure that the unit is cool enough to
work on.
• To remove the dust, wipe the appliance
with a dry cloth.
• Never use abrasive powders or solvents.
• If the heater shows any signs of wear or
damage disconnect immediately from
the mains supply, do NOT use it – have it
checked by a suitably qualied person.
WARNING:
DO NOT IMMERSE ANY ELECTRICAL PART
OF THE APPLIANCE IN WATER SUCH AS
MOTOR UNITS OR PLUGS.
PLEASE SEE CLEANING SECTION FOR
FURTHER INSTRUCTIONS.
DISPOSAL OF THE UNIT
Appliances bearing the symbol shown here
may not be disposed of in domestic rubbish.
You are required to dispose of old electrical
and electronic appliances like this separately.
Please visit www.recycle-more.co.uk or
www.recyclenow.co.uk
for access to information about the recycling
of electrical items.
Please visit www.weeeireland.ie for access to
information about the recycling of electrical
items purchased in Ireland.
The WEEE directive, introduced in August
2006, states that all electrical items must be
recycled, rather than taken to landll.
Please arrange to take this appliance to your
local Civic Amenity site for recycling, once it
has reached the end of its life.

9
www.warmlite.co
Model Identier(s): WL41001
Item Symbol Valve Unit Item Unit
Heat Output Type of heat input for electric storage, local space
heaters only (select one)
Nominal heat
output Pnom 2,0110 kW Manual heat charge with integrated thermostat N/A
Minimum heat
output (indicative) Pmin 0 kW Manual heat charge control with room and/or outdoor temperature feedback N/A
Maximum
continuous heat
output
Pmax, c 2,0110 kW Electronic heat charge control with room
and/or outdoor temperature feedback N/A
Auxiliary electricity
consumption Fan assisted heat output N/A
At nominal heat
output elmax N/A kW Type of heat output/room temperature control (select one)
At minimum heat
output elmin N/A kW Single stage heat output and no room temperature control No
In standby mode eISB N/A kW Two or more manual stages, no room
temperature control No
With mechanic thermostat room temperature
control Yes
With electronic room temperature control No
Electronic room temperature control plus day
timer No
Electronic room temperature control plus
week timer No
Other control options (multiple selections possible)
Room temperature control with presence
detection No
Room temperature control with open
window detection No
With distance control option No
With adaptive start control No
With working time limitation No
With black bulb sensor No
Contact Details: Imported by RK Wholesale LTD., Berryhill Road, Stoke-on-Trent ST4 2NL

10
CUSTOMER SUPPORT TEAM: [phone]
NOTES

11
www.warmlite.co
NOTES

0418.V6
We hope you enjoy your appliance for many years.
As a thank you for purchasing one of our fantastic products,
we are oering you an extra 1 year peace of mind.
*To receive your extra guarantee period, register your appliance online
within 28 days of purchase by visiting:
www.warmlite.co
Make sure to retain your original receipt.
Should you have a problem
with your appliance or need any spare parts please call our
Customer Support Team on:
[phone]
Distributed throughout the UK by RK Wholesale LTD