Parts Identication
Technical Data
This product is guaranteed for 12 months from the date of the original purchase.
If any defect arises due to faulty materials or workmanship the faulty products must
be returned to the place of purchase. Refunds or replacement is at the discretion
of the store.
The following conditions apply:
The product must be returned to the retailer with the original proof of purchase.
The product must be installed and used in accordance with the instructions
contained in this instruction guide.
It must be used only for domestic purposes.
It does not cover wear and tear, damage, misuse or consumable parts.
PFD has no responsibility for incidental or consequential loss or damage.
Valid in the UK and Eire only.
Guarantee.
CERAMIC OSCILLATING HEATER
AC: 220V-240V~50Hz
Power 1500W
Sutton House,
Berryhill Road,
Fenton
Stoke on Trent
Staffordshire,
ST4 2NL.
Imported & Distributed throughout the U.K.
By PFD. ST4 2NL www.warmlite-products.co.uk
WL44005
2
6
5
4
3
71
1. Fan Control Switch
2 Oscillation control button
3. Power light
4. Body
5. Base
6. Grill
7. ermostat Controller
SYMBOL FUNCTION
“OFF” OFF
“FAN” Fan only,no heat
“I” Low heat output
“II” Full heat output
GENERAL SAFETY INFORMATION
Read all instructions before using Heater.
Use this Heater only as described in this manual.Any other use not recommended
by the manufacturer may cause re, electrical shock, or injury to persons.
Make certain that the power source conforms to the electrical requirements of the
Heater.
Extreme caution is necessary when any Heater is used by or near children or the
inrm and whenever the Heater is left operating unattended.
The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
Children shall be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacture or its service
agent or a similarly qualied person in order to avoid a hazard.
Do not operate any Heater with a damaged cord or plug or after the Heater
malfunctions, has been dropped or damaged in any manner. Return Heater to au-
thorized service facility for examination, electrical or mechanical adjustment
or repair.
Unplug power cord before servicing or moving the Heater.Always unplug Heater
when not in use.
WARNING: DO NOT DEPEND ONTHE ON/OFF SWITCH AS THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING OF MOVING THE HEATER.ALWAYS
UNPLUG THE POWER CORD.
Do not insert or allow ngers or foreign objects to enter any ventilation or exhaust
opening as it may cause an electric shock or re, or damage the Heater.
Do not block or tamper with the Heater in any manner while it is in operation.
To prevent a possible re, do not block air intakes or exhaust in any manner.
Do not place on soft surfaces, like a bed, where openings may become blocked.
Always place the Heater on a stable, at, level surface when operating, to avoid the
chance of the Heater overturning. Locate the Power Cord so the Heater or other
objects are not resting on it. Do not run Power Cord under carpeting.
Do not cover Power Cord with throw rugs, runners, or the like.Arrange the Power
Cord away from room trafc and where it will not be tripped over.
This Heater is hot when in use.To avoid burns, do not let bare skin touch hot
surfaces.Always use handle when moving this Heater. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m)
from the front of the Heater and keep them at least 1 foot (0.3 m) from the sides
and rear.
WARNING:To avoid danger of electric shock, unplug from outlet when not in use
and before cleaning