WARRIOR WEP8370BC User manual

OPERATOR'S MANUAL
CHARGER #WEP8370BC
BATTERY #WEP8301-2.5
REV 20211220
SAVE THESE INSTRUCTIONS. This manual contains important safety precautions which should be read and understood before operating the product.
Failure to do so could result in serious injury. This manual should remain with the product.
Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without
notice.
LITHIUM-ION RECHARGEABLE
BATTERY & CHARGER
ENGLISH
DEUTSCH
FRANÇAIS
SVENSKA

PRODUCT SPECIFICATIONS
2
Battery
Battery Pack WEP8301-2.5
Battery capacity 2.0/2.5/4.0Ah Lithium-lon
Charge time From 67 to 150 minutes
Weight 1.54-2.09lbs (0.7-0.95kg)
Charger
Charger WEP8370BC
Input 120-240VAC, 50/60Hz.
Output: 42VDC, 2.2A
Weight 1.2lbs (0.55kg)
PRODUCT SPECIFICATIONS

GENERAL SAFETY RULES
3
EN
GENERAL SAFETY RULES
For the proper use, maintenance and storage of this
battery, it is important that you read and understand the
instructions given in this manual.
To avoid serious injury, risk of fire, explosion and danger
of electric shock or electrocution-
–Do not probe the charger with conductive materials.
The charging terminals hold 120-240V.
–If the battery pack case is cracked or damaged, DO
NOT insert into the charger. Replace the battery
pack.
–Do not charge these battery packs with any other
type of charger
–Do not allow liquid inside the charger.
–Do hot try to use the charger for any other purpose
than what is presented in this manual.
WARNING
If the battery fluid gets in your eyes, flush
immediately with clean water for at least 15
minutes Get immediate medical attention. Do not
charge the battery pack in rain or in wet conditions.
Do not immerse the tool, battery pack, or charger in
water or other liquid.
SAFETY NOTES AND PRECAUTIONS
1. Do not disassemble the battery.
2. Keep away from the children.
3. Do not expose the battery to water or salt water,
and store the battery in cool and dry environment.
4. Do not place the battery in high-temperature
locations, such as near a fire, heater, etc.
5. Do not reverse the positive terminal and the
negative terminal of the battery.
6. Do not connect the positive terminal and the
negative terminal of the battery to each other with
any metal objects
7. Do not knock, strike, or step on the battery
8. Do not solder directly onto the battery and pierce
the battery with nails or other sharp objects.
9. In the event that the battery leaks and the fluid
gets into one’s eye, do not rub the eye. Rinse well
with water. Immediately discontinue use of the
battery if the battery emits an unusual smell feels
hot, changes color, changes shape, or appears
abnormal in any other way
WARNING
To avoid risk of fire, electric shock, or electrocution
–Do not use a damp cloth or detergent on the
battery or battery charger
–Always remove the battery pack before
cleaning, inspecting, or performing any
maintenance on the tool.
BATTERY
–On opening the box, charge battery fully before first
use.
–Never allow the battery pack or charger to overheat.
If they are warm, allow them to cool down.
Recharge only at room temperature and not in very
hot conditions or extreme temperatures.
–Keep the ventilation slots of the charger clear.
–Never allow small metal items or material such as
steel wool, aluminum foil, or other foreign particles
into the charger cavity.
–Unplug the charger before cleaning and when there
is no battery pack in the charger.
–Do not leave the battery pack in the sun or in a
warm environment for extended periods of time.
–Never try to connect two chargers together.
–The battery pack cells may develop a small leak
under extreme usage or temperature conditions
–If the battery will not be used for 3 months or
more, Fully charge and store the battery in a room
temperature environment.
–If the outer seal is broken and the leakage gets on
your skin:
–Use soap and water to wash immediately.
–Neutralize with lemon juice, vinegar, or other mild
acid
–If leakage gets in you. r eyes, follow instructions
above and seek medical attention

BATTERY
4
CHECKING BATTERY CAPACITY
Note: The battery is not shipped fully charged. Fully
charge battery before first use to ensure that maximum
run time can be achieved. This lithium-ion battery will
not develop a memory and may be charged at any time.
A fully discharged battery pack will take the allotted time
as stated in the specifications portion of this manual
Press the battery capacity indicator button. The LED
lights will illuminate according to the batteries current
power level. See chart below:
Lights Capacity
4 Green LED are lit The battery is more than
70% capacity
4 Blue LED are lit The battery is between
35%and 70%capacity
4 Red LED are lit The battery is between
0%and 35%capacity
4 Red LED flash The battery requires
charging immediately
CAUTION
Do not use strong solvents or detergents on the
plastic housing or plastic components. Certain
household cleaners may cause damage and may
also cause a shock hazard.
WARNING
ENVIRONMENTALLY SAFE BATTERY DISPOSAL
The following toxic and corrosive materials are in
the batteries used in this blower.
Battery pack: Lithium-lon, a toxic material.
WARNING
All toxic materials must be disposed of in a
specified manner to prevent contamination of the
environment. Before disposing of damaged or worn
out Lithium-ion battery packs, contact your local
waste disposal agency, or the local Environmental
Protection Agency to information and specific
instructions. Take the batteries to a local recycling
and/or disposal center, certified for Li-ion disposal.
WARNING
If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Dispose of
it properly and replace with a new battery pack. DO
NOT ATTEMPT TO REPAIR IT! To avoid injury and
risk of fire, explosion, or electric shock, and to avoid
damage to the environment:
–Cover the battery’s terminals with heavy-duty
adhesive tape
–DO NOT attempt to remove or destroy any of
the battery pack components
–DO NOT attempt to open the battery pack
–If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in
the eyes or on skin, and do not swallow it
–DO NOT place these batteries in your regular
household trash
–DO NOT incinerate
–DO NOT place them where they will become
part of any waste landfill or municipal solid
waste stream
–Take them to a certified recycling or disposal
center

BATTERY CHARGER
5
EN
BATTERY CHARGER
WARNING
The battery is not shipped/transported fully
charged. Fully charge the battery before first use
to ensure that maximum run time can be achieved.
This lithium-ion battery will not develop a memory
and may be charged at any time.
CHARGING PROCEDURE
LED STATUS DESCRIPTION
Blinking Green Charging
Solid Green Fully charged
Solid Red Stand by
Blinking Red (fast) Battery too hot
Blinking Red (slow) Charging fault
Low voltage charging:
If the battery has been stored with little to no charge for
a long period of time, the charger will go into recovery
mode, which will take more time to fully charge the
battery. This will enhance the life of the battery. Once it
is fully charged, the next charge will return to standard
charging.
A fully discharged battery pack will require the allotted
time as stated in the battery manual. Plug the charger
into an AC power outlet.
Insert the battery -into the charger.
This is a diagnostic charger. The Charger LED Lights will
illuminate in specific order to communicate the current
battery status.
False defect note:
When the battery is inserted into the charger and the
status LED blinks RED, remove the battery from the
charger for 1 minute, then reinsert. If the status LED
blinks GREEN, then the battery is properly charging. If
the status LED is still blinking RED, remove the battery
and unplug the charger for 1 minute. After 1 minute,
plug in the charger and reinsert the battery. If the status
LED blinks GREEN, then the battery is properly charging.
If the status LED is still blinking RED, the battery is
defective and needs to be replaced
CHECKING THE CHARGE
If the battery pack does not charge properly:
Check the current at the power outlet with another tool.
Make sure that the outlet is not turned off.
Check that the charger contacts have not been shorted
by debris or foreign material.
If the air temperature is above 104°F or below
45°F, move the charger and battery pack to a room
temperature location and allow to warm up slowly.
WARNING
If the battery is inserted into the charger when
warm or hot, the CHARGING LED indicator light
on the charger may switch on and illuminate RED.
If this occurs allow the battery to cool inside of
the charger for up to 30 minutes. Charging should
automatically start once battery has cooled
CHARGER MOUNTING
–This charger can be installed hanging on a wall
using two #8 screws (not included).
–Locate the placement for the charger to be wall
mounted.
–If fastening to wood studs use 2 wood screws (not
included).
–Drill two holes on center 5.5 in. apart ensuring that
they are vertically aligned.
–If fastening to drywall use wall anchors (not
included) and screws to secure the charger to the
wall.
Note: If the battery and the charger won’t be used for a
long time, remove the battery from the charger and pull
out the AC power plug