Waterstone 1100 User manual

FILTRATION FAUCET INSTALLATION
INSTRUCTIONS
Model #s:
1100
1150
1200
1250
1202
1252
1400
1425
1450
1455
1700
1750
1900

LIFETIME WARRANTY UNDER SINK SYSTEMS
All Waterstone products manufactured by Waterstone carry a Limited Lifetime
Guarantee against functional defect in material or workmanship in a residential
application. Consult with an authorizedWaterstone dealer for complete information
about our warranty.
WARNING - Since 2005, Waterstone has continued to advise all of our customers against
the installation of any brand of in-line water chiller unit with our faucets. Compressor
style chiller units have been proven to arbitrarily exceed the standard household in line
pressure ratings causing the faucet inlet connection line to burst and create the potential
for water damage claims in the eld.
USE OF AN IN-LINE INSTALLATION OF A WATER CHILLER WITH A WATERSTONE
FAUCET OF ANY KIND WILL VOID OUR WARRANTY.
Waterstone can not and will not be held liable for damages created by a use for which
our products were not designed. Waterstone will only recommend the installation of a
water chiller in the vented side (in place of a hot tank) with one of our Hot or Hot & Cold
Filtration faucet models.
For any questions or concerns about your faucet’s warranty, contactWaterstone.
1-888-304-0660
www.waterstoneco.com
To complete your water ltration system,Waterstone
recommends adding our Multi-Stage Filtration Unit
and a Insta-Hot Tank. Along with your Waterstone
Filtration Faucet, create the ultimate under sink water
purication system. Systems are sold separately.
1 2 3 4
Turn o water supply. Observe all local
plumbing codes.
Inspect waste and water
supplies for signs of damage.
Replace as necessary.
DO NOT use petroleum
based products on this
faucet.
REQUIRED TOOLS: PARTS INCLUDED:
1. Adjustable Wrench
BEFORE YOU BEGIN YOUR INSTALLATION:
INSTALLATION GUIDE
COLD ONLY
HK-CFF-XX*
COLD ONLY FILTRATION
HARDWARE KIT
HOT ONLY
HK-FBF-XX*
HOT ONLY FILTRATION
HARDWARE KIT
HOT / COLD
HK-FBF-XX*
HOT/COLD FILTRATION
HARDWARE KIT
MULTI-STAGE FILTRATION UNIT
#30101
*XX represents nish
HOT TANK
#5000

RED HOSE
BLUE HOSE
CLEAR HOSE
A
B
C
D
E
F
1.
COUNTER
OR SINK
2. 3. 4.
Thread the nut (F) onto
threaded shroud. Hand
tighten nut to underside of
sink or counter.
Turn faucet to the desired
handle position. Securely
tighten nut with adjustable
wrench.
HOSE CONFIGURATIONS
FILTRATION FAUCET INSTALLATION
COLD ONLY -
OLDER MODELS
COLD ONLY HOT ONLY HOT AND COLD
Install escutcheon (A) onto
faucet shank (B).
No hose.
Fit exible hoses (C, D, E)
through hole on counter or
sink. (No plumbers putty is
required. Vinyl washer seals
base).
Waterstone oers three types of ltration faucets - Cold Only, Hot Only and Hot/Cold. Each model has it’s own unique hose conguration.The
faucets can be connected to a water ltration system and/or an instant hot water tank.

VEN-038-FILT Rev. E
41180 Raintree Court • Murrieta, CA 92562
1-888-304-0660 • 951-304-0520 • www.waterstoneco.com
A
B
1. 2. 3.
4. 5. 6.
COUNTER
OR SINK
C
D
E
G
F
EXTEND 1/4”
Slide large washer (C) and star lock washer
(D) onto shank.Thread the nut (E) and hand
tighten underside of sink or counter.
Turn faucet to the desired handle position.
Securely tighten nut with adjustable
wrench.
Slide compression nut
(F) over end of supply
tube. Slide ferrule (G)
onto end of supply
tube, long tapered
end rst.
Slide ferrule until 1/4”
of tubing is showing
out the end.
COLD ONLY FILTRATION FAUCET INSTALLATION (OLDER MODELS)
Slide escutcheon plate (A) onto threaded
shroud (B) and up to base of faucet.
Fit faucet shank through hole on counter
or sink. (No plumbers putty is required.
Vinyl washer seals base).
Insert extended
portion of tubing and
tighten compression
nut to end of faucet
shank with wrench.