Waterstone HUNLEY Series User manual

INSTALLATION INSTRUCTIONS
HUNLEY SERIES KITCHEN FAUCETS
3600-XX
Before you begin your installation:
1. Make sure your water supply is turned off
2. Observe all local plumbing codes
3. Inspect waste and water supplies for any signs of
damage and replace as necessary
4. Do not use petroleum based products on this faucet.
Recommended Tools and Materials
1. Phillips Screwdriver
2. Adjustable Wrench
FAUCET INSTALLATION (see diagram)
1. Remove the clamp nut (A) and washer (B) from the threaded
shroud (C) under the faucet and fit the faucet flexible
hoses and rigid sidespray tube through the hole on the
counter or sink. (No plumbers putty is required in that the
faucet has an O-ring seal built into its base).
2. Slide the washer and thread the clamp nut onto the threaded
shroud. Make sure clamp screws are screwed back and
thread the nut snug to the underside of the sink or counter.
3. Make sure the faucet is in the correct position you want it for
your sink and securely tighten the clamp screws.
CONNECT SUPPLY HOSES
1. Carefully position the hot and cold supplies so they will not
interfere with other hoses
2. Connect the supply hoses to the supply stops

ABC
Note the most common faucet installation is with the handle
positioned to the right. Pull the handle for hot water or push the
handle for cold water. If the handle is centered, press it to the right for
cold and to the left for hot water
If the handle is installed to the left, reverse the supply hoses (connect
the hose for cold water to the hot supply and the hose for hot water to
the cold supply). This will maintain the relationship of pulling the
handle for hot water or pushing for cold water.
CONNECTING OPTIONAL SIDE SPRAY
1. Mount side spray base in the side spray hole on your sink or
counter.
2. Tighten guide nut.
3. Fit sidespray hose through the side spray guide.
4. Remove the sidespray hose cap on the end of the sidespray
hose tube on the faucet.
5. Connect and tighten the end of the sidespray hose to the
sidespray hose tube underneath the faucet.
6 3/4"
8 1/4"
3 3/8"
12”
7 5/8"
SUPPLY HOSES- 20”
LONG WITH 3/8"
COMPRESSION FITTINGS
2-3/8" MAX
1 1/4”
2 1/4”
2 1/8”
(57mm)
(54mm)
(32mm) (60mm)
S I D E S P R AY C O N N E C T I O N
WI TH 1 /4 " NP T PI PE F IT TI NG
2 1/8”
13”
3”

WATERSTONE
Diverter replacement
3600-XX
series faucets.
1- Unscrew and remove upper faucet assembly (a).
2- Using a needle nose pliers or small hook, remove
old diverter (b) by pulling it straight up.
3- Insert the new diverter (c) by pushing straight
down. (Use a little liquid soap to lubricate the o-rings
before installation).
4- Re-install riser base, check for leaks.
a
b
c