Waterstone 3300 User manual

Potfiller Model #s:
3300
3350
3400
COUNTER MOUNTED POTFILLER
INSTALLATION INSTRUCTIONS
3200
3100 3150
3300 3350 3400

LIFETIME WARRANTY
All Waterstone products manufactured by Waterstone carry a Limited Lifetime
Guarantee against functional defect in material or workmanship in a residential
application. Consult with an authorizedWaterstone dealer for complete information
about our warranty.
For any questions or concerns about your faucet’s warranty, contact Waterstone.
Waterstone Faucets
41180 Raintree Court • Murrieta, CA 92562
1-888-304-0660
www.waterstoneco.com
1 2 3 4
Turn o water supply. Observe all local
plumbing codes.
Inspect waste and water
supplies for signs of damage.
Replace as necessary.
DO NOT use petroleum
based products on this
faucet.
REQUIRED TOOLS: PARTS INCLUDED:
2. Phillips Screwdriver1. Adjustable Wrench
BEFORE YOU BEGIN YOUR INSTALLATION:
INSTALLATION GUIDE
HK-CPK-XX*
HANDLE BUTTON KIT (TRADITIONAL ONLY)
HK-USM1250
UNDER SINK MOUNTING HARDWARE KIT (1-1/4”)
*XX represents nish

A
BD
E
C
COUNTER
OR SINK
1. 2.
3. 4.
Slide washer and thread the
clamp nut onto threaded
shroud. Tighten nut snug to
underside of sink or counter.
Turn faucet to the desired
handle position. Securely
tighten clamp screws (E).
COUNTER MOUNTED POTFILLER INSTALLATION
Remove clamp nut (A) and
washer (B) from threaded
shroud (C).
Fit exible hose (D) through
hole on counter or sink. (No
plumbers putty is required.
O-ring seals base).

VEN-038-CMPF Rev. C
41180 Raintree Court • Murrieta, CA 92562
1-888-304-0660 • 951-304-0520 • www.waterstoneco.com
H C
COMPASS H/C FINISH MATCH
3350 3300
Each traditional style Waterstone Counter Mounted Potller
includes a choice of 2 decorative handle buttons.
OPTIONAL DECORATIVE BUTTON
(TRADITIONAL ONLY)
1. Place a small standard screwdriver in the slot at
the bottom of metal ring that surrounds the handle
button. Gently pry the button from faucet handle.
2. Position button and snap in with thumb.
1. Before connecting supply hoses, ush supply stops to clear any debris. Place a bucket underneath stops
and run water for 5 to 10 seconds. Turn water o.
2. Carefully position hot and cold supplies so they will not interfere with other hoses.
3. Connect supply hoses (A) to supply stops (B). DO NOT use teon tape or plumbers putty. Turn water back
on and check for leaks.
CONNECTING SUPPLY HOSES
A
B
1. Gently unscrew and remove spout tip (A) by hand.
2. Remove O-ring (B).To remove aerator (C), push with nger from bottom.
3. Thoroughly rinse aerator with water until all debris is removed.
4. Place aerator, then O-ring back into spout tip.
5. Gently screw spout tip, by hand, snuggly back onto spout.
Depending on quality of your household water, the aerator
and debris screen may become clogged.We recommend
cleaning one week after installation, then a minimum of
once of year thereafter. To remove the debris, follow the
steps below.
CLEANING AERATOR AND DEBRIS SCREEN
B
C
A
1. 2. 3. 4. 5.