Waterstone AG245-1 User manual

BEFORE YOU BEGIN YOUR INSTALLATION:
II
23
Turn off water
supply.
Phillips Screwdriver
Observe all local
plumbing codes.
1 /4" Hex Key Wrench Adjustable Wrench
Inspect plumbing for
signs of damage.
Replace as necessary.
Read these instructions and plan the installation before beginning.
Risk of product damage. Do not apply direct heat to the valve. Excessive heat will
damage the plastic components and plaster guard. •A mixed water supply is required
for this product.
Component location, spacing, and situational requirements can vary.
IMPORTANT
DO NOT use
petroleum based
products on this faucet.
REOUIRED TOOLS AND
MATERIALS:
WARNING: Cancer and reproductive harm -see www.P65Warnings.ca.gov
-4
FLOOR MOUNT, TUB FILLER
Model # AG245-1
Installation Guide

Remove Mud Guard from Valve Remove Valve Plug
Prep tub filler for installation by raising the
escutcheon and securing it so that it does not
scratch the tubing.
Grease O-rings on bottom of tub filler.
1 2
3 4

Place tub filler on valve. Adjust alignment until desire orientation is
achieved.
Use provided socket head screws and
serrated washers to fasten tub filler to valve.
Open both hot and cold shut offs on rough-in valve.
5 6
7 8

Slide the Escutcheon down to the floor.
10
9
11
1-888-304-0660 • 951-304-0520
www.waterstoneco.com
Place a small bead of calk around the base to
seal the floor.
Install the Hose and place Hand Shower in
the Cradle.