WATSON Haven Neighborhood Light User manual

ASSEMBLY
360.394.1300 watsonfurniture.com
V.21.0 10/2021
Haven Neighborhood Light

2 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Recharge Bench Components
Shade Light Disc Stem
Power Supply Bracket
Power Supply

3 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Hardware
Mounting Washer Locking Washer Mounting Nut Thread Cutting
Screw
M4 X 12mm
Spacer (used
only for the
bench assembly)
Connector
Housing
Light Rod 60mm
(used for bench and
table surface only)
Light Rod 100mm
(used for rail assembly
only)
Tools
Electric Drill Phillips Bit
13mm Wrench

4 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
1.
a.
b.
Attach Light Rod
Pass the small connector cables in the light stem through the light rod (a.) and slide the light rod over the cable and up
to the light stem (b.). Screw the light rod into the threaded plate in the light stem, and use the at sections on the end
of the light rod to tighten fully into the bottom of the lamp (c.).
Light Rod 60mm
c.

5 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Place Light Stem
Pass the cables through the hole in the table surface and insert the stem into the mounting hole. Position the
stem so the alignment pins go through the alignment holes in the surface.
2.

6 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Secure Light Stem
Pass the cables rst through the mounting washer, then the lock washer, and last the mounting nut, and secure the stem
to the surface by tightening the mounting nut to the light rod.
3.
Mounting Washer Locking Washer Mounting Nut

7 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Attach Connector Housing
Once you have secured the lamp stem, attach the connector housings onto the ends of the cables. Once inserted, gently
pull on the wire to ensure a strong connection.
10.
Connector
Housing

8 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Attach Light Disc
Plug the connector from the light disc into the
connector from the stem (a.) and feed the excess
cable down into the stem. Secure the light disc to
the stem using (3) at head screws (b.).
11.
Thread Cutting Screw
M4 X 12mm
a.
b.

9 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Secure Power Supply
Secure the power supply bracket to the underside of the surface using (2)
screws (a.). Slide the power supply into the bracket until it clicks into place.
12.
10 X 3/4” Pan
Head Screw
(122875)
a.
b.

10 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Connect Power
Connect the plugs from the power supply to the connectors on the light, making sure to connect red to red and black
to black. Secure excess cable to the surface using the supplied alligator clips to keep it out of the way. Plug into power
source and test.
13.

11 HAVEN NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS
Attach Light Shade
Press the shade onto the light disc, applying even pressure around the perimeter until a snug and level t.
14.