WE-EF MRY224 User manual

Surge Protection
This product features built-in surge protection circuitry in compliance with
applicable standards.
For comprehensive protection of a luminaire installation against lightning and
electrical surges, it is essential to cover mains supply and data input lines at
the distribution board level, by using respective primary (Type 1) and secondary
(Type 2) surge arrestors in compliance with EN61643-11/IEC61643-1.
Warning
Ensure that all required surge protection measures are in place and activated
prior to luminaire installation. Also, disconnect luminaires before operating
high-power devices such as, for example, electrical arc welders.
Do not open during installation
This product is factory-sealed.
Refer to the instructions contained in this
document for details.
WE-EF LEUCHTEN
Installation and Maintenance
Instructions
Bollards and Pathway Luminaires
MRY224
Installation tools
Mounting hardware used on this product
includes fasteners with hexalobular socket
heads (ISO 10664). Installation requires the use
of matching tools.

1
Bollards and Pathway Luminaires
IP66, IK10, Ta = 25°C for 15 W with 1-10 V dimming, for other Ta= 40°C
Tool required
– Torx T25 (provided by WE-EF)
Weight Hkg
for MRY224 600 8.0
for MRY224 850 10.8
for MRY224 1000 12.4
Accessories:
Planted root – Galvanised steel. kg
ESZ4 for MRY224 300-9090 3.5
ESZ4
MRY224

2
Light Source
LED
Maintenance
Apart from cleaning the product’s exterior surfaces, no special maintenance work is required.
Do not use high-pressure cleaners.
In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out
E\DVXLWDEO\TXDOLƂHGDQGWUDLQHGSURIHVVLRQDO
Warning: Do not open luminaire while mains supply is switched on.

3
Installation
The product must be installed and maintained by a
VXLWDEO\TXDOLƂHGSURIHVVLRQDOLQFRPSOLDQFHZLWKODWHVW
building/construction and/or electrical regulations and
relevant legislation.
Warning: Switch off mains electrical supply prior to
installing and connecting the luminaire.
Notice:,IWKHOXPLQDLUHLVPRGLƂHGE\DQ\ERG\RWKHU
than the original manufacturer, then the warranty will
no longer be valid and shall become the full respon-
sibility of the modifying person/organisation. Claims
based on defects attributable to improper installation
and/or application, and the consequences thereof, are
excluded.
Attention: The luminaire is factory-sealed and does
not need to be opened during installation.
The installation on site must comply with local and/or
national health and safety regulations.

4
1) Switch off mains electrical supply.
Installation Procedure
2) Loosen screw A.
4) Pull cable D through centre-hole. Ensure
orientation of post C allows easy access to
terminal block G DQGVFUHZƃDQJHSODWH E
with M10 bolts/nuts to ground.
An optional planted root is available.
Note: Planted root installation instruction is
available in additional document.
3) Remove sleeve Bincluding luminaire head
from post C.
A
LN C
B
D
G
E
C

5
5) Check that rating shown on luminaire label
conforms to mains electrical.
(example)
6) Pull cable D(and second cable for through
wiring, if required) through cable clamp F
and terminate in terminal block G:
a) ON/OFF (L = Phase, N = Neutral,
= Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
For operation with Tunable White, a DALI
DT8 controller is required.
7) Place sleeve Bincluding luminaire head
over post Cwhile keeping screw Ain line
with terminal box.
LN
LN D
F
G
LN
A
B
C
MRY224 220-240V/50 Hz 1-10
115-XXXX SOE XXXXXXX
LED 3000K 15W item no. XXX
04/20 IP66/IP67
4.2)For one-sided light output only, the direction
of light is opposite terminal block G.
Orientation of light must be decided prior to
installation of post C.
G
Direction of light
C

6
8) Align sleeve BDQGƃDQJHSODWHE. 9) Tighten screw A with Torx T25 tool
(provided by WE-EF).
A
E
B

www.we-ef.com
WE-EF LEUCHTEN
Germany
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LUMIERE
France
Tel [phone]
Fax [phone]
[e-mail]
WE-EF HELVETICA
Switzerland
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
Thailand
Tel [phone]
Fax [phone]
LQIRDVLDSDFLƂF#ZHHIFRP
WE-EF LIGHTING
Australia
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
United States of America
Tel [phone]
Fax [phone]
[e-mail]
TO9268W0521 © WE-EF 2021
7HFKQLFDOVSHFLƂFDWLRQVDUH
subject to change.