weBoost Home 4G User manual

TM
Cellular Signal Booster
460101
Need help? www.WilsonElectronics.com Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
ENGLISH FRANÇAIS
Package Contents
Quick Install Diagram
Connect 4G Signal Booster
Panel Antenna Kit
Outside Antenna Kit
AC Power Supply
Wall & Pole Mount
Brackets
Coax cable &
Window Entry Cable
Find the Strongest Signal
Outside Antenna Installation
Connect Coax Cables to Connect 4G
Inside Antenna Installation
Connect Power Supply
NEED ASSISTANCE? WE CAN HELP!
Contact our U.S.- BASED CUSTOMER SUPPORT:
nContact our U.S.-based customer support team at
1-866-294-1660 or email at [email protected]
n Go online for how to resolve the most common issues at
www.weboost.com/us/customersupport
nFind a weBoost Installer on our web site at
www.weboost.installernet.com
Installation is simple, but we’re here to make it even easier.
Your cell phone is an essential part of your life. weBoost is here to
ensure you have seamless connections on all your cellular devices.
The Connect 4G cellular signal booster is a effective solution to all
those times you’ve had to walk into another room, or even outside,
to nd a stronger, more reliable cell signal. Installation is simple and
can be completed with minimal tools.
Note: How It Works
Inside Antenna
Connect 4G
Signal Received
and Transmitted
See install guide for additional mounting options.
For more information refer to full Install Guide at:
www.weboost.com/us/installguide/connect4G
Connect 4G™
Quick Install Guide
Lightning
Surge Protector
(sold separately)
To Outside
Antenna
To Signal Booster
Ground Wire
(not included)
RECOMMENDED: INSTALLING THE LIGHTNING SURGE
PROTECTOR (SOLD SEPARATELY)
INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE
TO THE SIGNAL BOOSTER. ATTACH THE CABLE FROM THE
OUTSIDE ANTENNA TO THE SURGE PROTECTOR. ENSURE
THE LSP IS PROPERLY GROUNDED.
#859992-75 ohm may be purchased at
www.weboost.com or by calling 800-204-4104.
Product Registration
Thank you for purchasing this weBoost product. Please take time to
register your new product at our website:
www.weboost.com/us/productregistration
Registering is quick and easy, it only takes 2-3 minutes to complete.
Your information is secure, we don’t share or sell your information
to other third parties.
TM
Cellular Signal Booster
460101
Need help? www.WilsonElectronics.com Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
ENGLISH FRANÇAIS
3301 East Deseret Drive, St. George, UT 84790
web: www.weboost.com email: [email protected]
phone: [phone] local: 435-673-5021 fax: [phone]
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
RF Safety: Any antenna used with this device must be located at least 8 inches from all persons.
FCC ID: PWO460020 IC 4726A-460020 FCC ID: PWO460001 IC 4726A-460001
111497R_Rev01_07.05.16
RECOMMENDED: TO PROTECT THE BOOSTER FROM POWER
SURGES, CONNECT TO A POWER STRIP.

Find the Strongest Signal Outside Antenna Installation Connect Coax Cables to Connect 4G
Inside Antenna Location Inside Antenna Installation Connect to Power Supply
Check the bar indicator on your cell phone display and note where
the signal appears the strongest. NOTE: Cell phone bars are only
an approximation of signal strength and vary from phone to phone.
Be patient and repeat your signal check several times. NOTE:
Create a “soft” install rst by testing components in your proposed
locations before securing them with hardware.
Select a location on the roof or an outside wall where the Outside
Antenna can be mounted without obstruction. After connecting
the coax cable to the antenna, run it underneath the down side of
your roof’s ashing.
Refer to the full install guide for instructions on use of Window
Entry Cable at www.weboost.com/us/installguide/connect4G
Connect the coax cable from Outside Antenna to the Connect 4G.
Connect the coax cable from Inside Antenna to the Connect 4G.
Maintain a vertical distance of at least 20 feet or a horizontal
distance of at least 50 feet between the Outside Antenna to the
Inside Antenna.
After the desired location for the Inside Antenna has been
determined use the Wall Bracket and hardware to mount to the
wall.
Connect the AC Power Supply to the Connect 4G then to a surge
protected AC power strip with at least a 1000 Joule rating. If your
Connect 4G is working correctly, the lights will be green.
NOTE: If lights (lights may appear dim) are not green on your
weBoost booster, please refer to the full install guide online or
contact customer support at 1-866-294-1660 or email at
[email protected].
1 2 3
4 5 6
Power Supply
Surge Protected
Power Strip
Inside Antenna
Wall Bracket
Drywall
Inside
Antenna
Connect 4G
Outside
Antenna
50 feet - horizontal distance
or 20 feet vertical distance
Directional Outside
Antenna
Directional Outside Antenna Inside Panel Antenna