Wenger StageTek Roll-A-Deck User manual

Assembly Instructions
StageTek
®
Roll-A-Deck
®
Accessory
©Wenger Corporation 2021 Printed in USA 2021-09 Part #280A553-02
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: (800) 4WENGER (493-6437) • Worldwide: [phone] • wengercorp.com
Note: Please read and understand these instructions before installing.
Note: If you need additional information, contact Wenger Corporation using the information below.
Visit the StageTek web page at wengercorp.com for detailed instructions and videos.
Make sure anyone assembling or
installing the StageTek component has
read and understands the instructions.
Always comply with Warnings
or Cautions in the instructions
or posted on the equipment.
Basic Instructions only!
For Replacement Parts and more detailed product information,
refer to the StageTek Owner's Manual 280A099.
!CAUTION !CAUTION

2
Assembly
1. Lay the StageTek deck upside down on a clean surface.
2. Attach the leg Assemblies.
a. Insert the leg tube all of the way into each of the pocket assemblies.
b. Secure each leg tube by hand tightening the knob on every
pocket assembly. No tools are required.
c. Turn the deck over onto the casters.
Multiple Roll-A-Decks can be connected together.
1. For best stability, attach connectors as high up
on the leg tube as possible.
2. Withtheatsidefacingout,ttheconnector
over the adjacent leg tubes.
3. Attach the connector to each leg tube
by closing the bolt and securing
with a wing nut.
Caster
Knob
Pocket
Assembly
Fit Connector
over the
Leg Tubes
(at side out)
Close
Bolt Wing
Nut
Wing
Nut
The deck can be unstable if the leg
assemblies are not properly attached.
!WARNING
Leg
Tube