Westin 46-20055 User manual

9/20/13 PG-1
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank You for choosing Westin products
For Additional installation assistance please call
Customer service [phone]
www.westinautomotive.com
P.N.: 75-3035-Rev A ECO #: W13-0076
APP PART # 46-20055
FLIP-UP WINCH TRAY LICENSE RELOCATOR
ITEM QUANTITY DESCRIPTION TOOLS NEEDED
11TRAY SIDE MOUNTING BRACKET 10MM WRENCH
21LICENSE SIDE MOUNTING BRACKET 8MM WRENCH
32NYLON SPACER 16MM WRENCH
42M6 BUTTON HEAD BOLT (STAINLESS) ALLEN KEY (INCLUDED)
52M6 NYLOCK NUT (STAINLESS) PHILLIPS SCREWDRIVER
64M6 FLAT WASHER (STAINLESS)
72M5 PHIL PAN SCREW (STAINLESS)
82M5 HEX NUT (STAINLESS)
92M5 LOCK WASHER (STAINLESS)
10 4M5 FLAT WASHER (STAINLESS)
INSTRUCTIONS—INSTRUCCIONES—CONSIGNES
AUTOMOTIVE PRODUCTS, INC.
1. Remove contents from box, verify if all parts listed are present and free from damage. Carefully read and understand all instruc-
tions before attempting installation. Anti-seize lubricant must be used on all stainless steel fasteners to prevent thread galling.
2. Remove the fasteners attaching the fairlead to the winch tray.
3. Slip the Tray Side Mounting Bracket between fairlead and the winch tray. Re-attach the fairlead using the fairlead manufactur-
er’s hardware. Adjust the fairlead and Tray Side Mounting Bracket as necessary then torque the fairlead hardware per the fair-
lead manufacturer’s instructions.

9/20/13 PG-2
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank You for choosing Westin products
For Additional installation assistance please call
Customer service [phone]
www.westinautomotive.com
P.N.: 75-3035-Rev A ECO #: W13-0076
CARE INSTRUCTIONS
 REGULAR WAXING IS RECOMMENDED. DO NOT USE ANY TYPE OF POLISH OR WAX THAT MAY CONTAIN ABRASIVES
 STAINLESS STEEL PRODUCTS CAN BE CLEANED WITH MILD SOAP AND WATER. STAINLESS STEEL POLISH SHOULD BE USED TO POLISH SMALL SCRATCHES.
 GLOSS BLACK FINISHES SHOULD BE CLEANED WITH MILD SOAP AND WATER
4. Insert the Nylon Spacers between the Tray Side Mounting Bracket and the License Side Mounting Bracket. Loosely attach the
License Side Mounting Bracket to the Tray Side Mounting Bracket using the supplied M6 hardware.
5. Check the swivel movement of the License Side Mounting Bracket. Tighten the M6 Nylock Nuts as necessary in order to create
some resistance while allowing the bracket to swivel. The resistance will help maintain the License Side Mounting Bracket in the
vertical position during winching.
6. Install the vehicle’s license plate using the supplied M5 hardware.
7. Check the operation of the unit. The hooks on the passenger side of the bracket should lock when pushed in the down position.
To unlock push in on the front of the License Side Bracket while simultaneously pulling on it’s side.