WeTech DP669USB User manual

© WEMPE Elektronic GmbH, created: 12.12.2018 Made in Germany
USER MANUAL
DP669USB
Thank you for purchasing a WeTech® product. This user manual contains important safety
and operating instructions for your desk programming station (DP). Before using your DP, read
this manual and all warning instructions with care in order to avoid possible danger.
This product is suitable for charging and programming MOTOROLA MTP3250 and MTP6750
radios with a MOTOROLA NNTN8023 rechargeable batteries.

2
Safety instructions
1. Installation and the first start of the system should only be done by qualified technicians.
2. Using rechargeable batteries not explicitly listed in this document may lead to fire.
3. The contacts of the product should be cleaned at regular intervals with a dry cloth. Do not
use water or other liquids.
4. The ventilation slots must not be covered.
Scope of delivery
The following items are included in the scope of delivery:
1x DP669USB
1x Power cable
1x USB cable
1x User manual
Start of the system
1. Place the DP at a suitable place. Ensure a safe stand!
2. Connect the delivered power cable to the power connection (F) at the device and a
socket.
3. Connect USB port (D) of the DP with a suitable PC.
4. Press the main switch (G).
5. You can now use your DP relating to the specifications of your programming software.
Advice
Each charger is protected by a 1.5A fuse inside of the DP on a separate board. More
information about surrogate fuses are in the technical data.

3
Functions
The DP is used for quick charging, maintaining charge and programming of radios. The table
below provides information about the function of the displays and the connections of the unit.
Pos.
Designation
Status
Description
A
Green LED
on
Battery detected.
off
Battery not detected. Contact with the radio
unit may not have been established properly.
B
Red LED
on
Quick charging active. Battery capacity under
80%
off
Quick charging inactive. Battery capacity over
80%
C
Green LED
on
Electricity supply is given
D
USB-B
Connection to PC
E
USB-A
Programming port for MRT over USB-cable
F
EURO-Buchse
Power supply
G
Main switch
For power supply
H
12V / 1A
Power supply for MRT
I / J
Not in use
Schematic drawing similar DP669USB

4
Technical data
Designation
Value
Working voltage
110V … 240V (AC)
Output voltage
5.1V
Output current
max. 880mA each charger
Fuse
6.3 x 32 mm² or 5 x 20 mm² / 1.5A / Inert
Degree of
protection
IP20
Measurements
550 x 145 x 146 mm³
Weight
3,8 kg
Additional instructions
CE conformity declaration
For this product, we confirm that it meets the requirements set forth in the Directive of the Council for Conformity
of Legal Regulations of Member States regarding Electromagnetic Compatibility. This declaration applies to all
units manufactured in accordance with the production drawings included as a component of this declaration.
WEEE (this symbol applies only in the European Union)
This symbol indicates that the product so labelled may not be disposed of with normal household waste. If you
want to dispose of this product, obey the corresponding national laws and regulations in your country or
community. The correct disposal of this product supports environmental protection and prevents possible
damage to the environment and human health.
Contact
This product was manufactured in Germany by:
WEMPE Elektronic GmbH phone: [phone]
Leinenweberstr. 6 fax: [phone]
DE-36251 Bad Hersfeld website: www.wetech.de
e-mail: [email protected]