Whitewood Furniture T-3660XB User manual

ITEM
NO.
: T
-
3660XB
REVISED JAN 18, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: BUTTERFLY LEAF EXTENSION E t
TABLE WITH TURNED LEG
: T-3660XB

ITEM
NO.
: T
-
3660XB
REVISED JAN 18, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PARTS LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Q’ty
Sketch
NO
Description
Q’ty
Sketch
A Top 1 B Leg 4

ITEM
NO.
: T
-
3660XB
REVISED JAN 18, 2014
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Q’ty
Sketch
NO
Description
Q’ty
Sketch
1 Flat washer
(8.5x19mm) 8 2 Lock washer (8.5x13mm) 8
3 Hexagon nuts
(M8x13mm) 8 4 Wrench
(M13mm) 1
5
Short bolt
( M6 x 35mm)
4
6
Lock washer
(6.5x11mm)
4
7
Flat washer
(6.5x16mm)
4 8
Allen key
(4x80mm)
1
STEP 1
Twist the wood stopper, and attach to the Top (A) with bolt (5) and washers (6), and (7) as shown
below. Tighten with the Allen key (8).

ITEM
NO.
: T
-
3660XB
REVISED JAN 18, 2014
Printed in Vietnam
- 4 -
STEP 2
Attach legs (B) to top (A) as shown below, using washers (1) and (2), and nuts (3). Tighten with the
wrench (4).
STEP 3
Place the table in an upright position, unlock the table top from both sides underneath of the top as
shown below. Pull the 2 sides apart.

ITEM
NO.
: T
-
3660XB
REVISED JAN 18, 2014
Printed in Vietnam
- 5 -
STEP 4
Fold the center leaf to store it underneath the table top, or leave it open as you choose. Lock the
top as shown below.