Whitewood Furniture BD-2003 User manual

ITEM NO: BD-2003
REVISED JUL 26, 2016
Printed in Vietnam
- 1 -
Description
Item No.
: COTTAGE 3 DRAWER NIGHTSTAND
: BD-2003
ASSEMBLY INSTRUCTIONS

ITEM NO: BD-2003
REVISED JUL 26, 2016
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish
of your product. Protect the surface of the product with cloth if you are using any product
with rubber feet or base.
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO: BD-2003
REVISED JUL 26, 2016
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Wooden knob
(30x30mm)
3
4
Long screw
(M4x30mm)
1
METAL KNOB
(35x30mm)
GOES WITH FINISHED
ITEM ONLY.
3
5
Steel band
1
2
Pan head screw
*Metal knob: (M4x22mm)
*Wooden knob: (M4x25mm)
3
6
Warning label
3
3
Short screw
(M3.5x15mm)
2
NO
Description
Qty
Sketch
A
3 DRAWER NIGHTSTAND
1
B
LEG
4

ITEM NO: BD-2003
REVISED JUL 26, 2016
Printed in Vietnam
- 4 -
STEP 1
Lift the nightstand (A) to attach legs (B) by screwing them into nightstand (A), as shown below.
STEP 2
Attach knobs (1) to front of drawers with pan head screws (2) as shown below. Tighten with a screwdriver.
Stick the warning labels (7) inside the drawers before use.

ITEM NO: BD-2003
REVISED JUL 26, 2016
Printed in Vietnam
- 5 -
STEP 3
Attach the steel band (5) to the nightstand with screws (3) and attach the steel band (5) to the wall
with screw (4) as shown below (to secure the product and prevent tipping). Tighten with a screwdriver.