Whitewood Furniture 3070 User manual

ITEM
NO.
:
3070
REVISED JUN 28, 2013
Printed in Vietnam
- 1 -
Description
Item No.
: 30” MISSION PLANT STAND
: 3070
ASSEMBLY INSTRUCTIONS

ITEM
NO.
:
3070
REVISED JUN 28, 2013
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A TABLE
TOP 1
B SIDE
FRAME 2
C SHELF
BOTTOM 1

ITEM
NO.
:
3070
REVISED JUN 28, 2013
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 BOLT
(M6x35mm) 8
2
FLAT WASHER
(6.5x19mm)
8
3
LOCK WASHER
(6.5x13mm)
8
4 ALLEN KEY
(4X80mm) 1
STEP
1
Attach side frames (B) to top (A) with bolts (1), and washer (2), and (3) as shown below. Tighten with
Allen key (4).

ITEM
NO.
:
3070
REVISED JUN 28, 2013
Printed in Vietnam
- 4 -
Attach shelf bottom (C) to side frames (B) with bolts (1), and washer (2), and (3) as shown below.
Tighten with Allen key (4).
STEP
2