Whitewood Furniture C-18 User manual

ITEM NO : C-18
ISSUED SEP 3, 2015
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: BIRDCAGE CHAIR RTA
: C-18

ITEM NO : C-18
ISSUED SEP 3, 2015
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws, bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Chair back
1
B
Seat Frame
1
C
Chair Seat
1
D
Front Leg
(L-R)
2
E
Side
Stretcher
2
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO : C-18
ISSUED SEP 3, 2015
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Short bolt
( M6x40mm)
3
2
Medium bolt
(M6x60mm)
4
3
Long bolt
(M6 x 80mm)
4
4
Screw
(M4 x 35mm)
8
5
Flat Washer
(6.5 x19mm)
11
6
Lock Washer
(6.5 x11mm)
11
7
Allen Key
(M4x80mm)
1
STEP 1
Attach seat frame (B) to the back (A) with bolts (1) and (3), and washers (5) and (6), as shown below.
Tighten with Allen key (7).
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to
make sure the chair is level and then tighten the bolts.

ITEM NO : C-18
ISSUED SEP 3, 2015
Printed in Vietnam
- 4 -
STEP 2
Attach front legs (D) to the seat frame (B) with bolts (2), and washers (5) and (6). Tighten with Allen
key (7).
Attach side stretchers (E) to front and back legs with screw (4) as shown below. Tighten with a
screwdriver.
STEP 3
Attach the seat (C) to top of the seat frame (B) with screws (4) as shown below. Tighten with a
screwdriver.