WiebeTech G5J User manual

G5Jam from WiebeTech
www.wiebetech.com
[email protected]
316 744 8722
866 744 8722 (toll free)
316 744 1398 (fax)
READ THE FOLLOWING BEFORE INSTALLING OR USING YOUR G5JAM.
WARNINGS AND SPECIAL INSTRUCTIONS:
1) NEVER ship or transport your G5 computer with the G5Jam installed. Doing
so may cause damage to your G5 and may void your computer’s warranty.
2) ALWAYS check to ensure that the PCI cards installed in your G5 computer
do not physically interfere with the drives on your G5Jam. Slot 4 (the top
slot) should accommodate full length PCI cards; while slots 1 through 3 will
only accommodate shorter PCI cards.
3) ALWAYS use extreme caution when installing or closing the G5Jam, in order
to ensure that the drives do not hit PCI cards and that the power and Serial
ATA cables are properly routed.
4) USE the hex key wrench included with the G5JAM or a bent paper clip (or
anything similar) to open the G5Jam. Insert the short end through the small
round hole and pull the G5Jam outward.
5) DO NOT ALLOW the G5Jam to fall over when pulling it out. Always
support it with one hand when pulling it out.
If you have any questions, please do not hesitate to email us. We are eager to help!