Wildridge Heritage LCC-165 User manual

ASSEMBLY INSTRUCTIONS
heritage picnic table with
attached benches
330-893-4212 • www.wildridge.com
LCC165
© 2021
Step 1
Lay table top (A) upside down on a soft surface and attach one of
the leg assemblies (B) with (4) 5/16” x 3 1/2” carriage bolts and (4)
5/16” ange nuts, two per leg. Repeat with the other leg assembly.
Step 2
To support the leg assembly, place a brace (C), turning it so the end
with no holes is towards metal frame as shown, and attach with
(2) 1 1/4” screws through the hole in the frame and into the brace.
Required Tools:
- Mallet/Non Marring
Hammer
(Do not use Metal Headed
Hammer)
- 1/2" Wrench or
Socket
- #2 Square Drive bit
- Cordless Drill
Hardware:
- (8) 5/16" x 3 1/2"
Carriage Bolts
- (8) 5/16” Flange Nuts
- (8) 2 1/2" Screws
- (4) 1 1/4” Screws
- (4) 2” Screws
Parts:
A = (1) Table Top
B = (2) Leg Assemblies
C = (2) Braces
D = (2) Seats
D
D
A
B B
C
B
A
B
C

ASSEMBLY INSTRUCTIONS
heritage picnic table with
attached benches
330-893-4212 • www.wildridge.com
LCC165
© 2021
Step 5
On the underside of the seat, fasten with (2) 2 1/2”screws by going
through the block and into the frame, do the same on the other
end. Repeat Steps 4 & 5 with the other seat.
Your table is now complete.... enjoy!
Thank you for purchasing from Wildridge.
Step 3
Next, attach the other end of the brace to the leg assembly, with
(2) 2” screws, as shown. Repeat Step 2 & 3 with the other brace on
the other leg assembly.
Step 4
Set the table up on its side, and place one of the seats into the
notches provided in the frame.
D