Wildridge LCC-207 User manual

Assembly Instructions
© 2017
LCC-207 Mission Glider
Required Tools:
- Hammer
- Cordless Drill
- #2 Square Drive bit
- 9/16” and 7/16” Wrench or
Socket
Hardware:
- (4) 1/4” x 2” bolts
- (2) 1/4” x 4” bolts
- (2) 1/4” x 3 1/2” bolts
- (8) 1/4” Flange Nuts
- (4) Glider Hangers
- (8) 3/8” x 2 1/2” bolts
- (16) 3/8” washers
- (8) 3/8” locknuts
- (4) 1 1/4” screws
- (8) 3” screws
www.wildridge.com
330-893-4212
Step 1
Position seat (B) and back (A) as shown
and fasten outside supports with (4) 2"
bolts & nuts. Use 1/2" x 1 1/2" x 5" con-
nector block provided to fasten center seat
support to the back using (4) 1 1/4"
screws.
Step 2
Fasten the arm leg assembly (C) in position shown
using 4" bolt & nut in back and 3 1/2" bolt & nut in
front. Repeat other side. Note: left & right.
A
BCC
D D
E

Assembly Instructions
© 2017
LCC-207 Mission Glider
www.wildridge.com
330-893-4212
Step 3
Position glider base assembly (D) and base supports (E)
as shown and fasten with (8) 3" screws through counter
sink holes provided.
Step 4
Now mount glider hangers on base as shown using (4)
3/8" x 2 1/2" bolts with 3/8" washer & nuts. First slide
a washer on bolt and push through hole provided from
inside to outside. Add another washer then hang a glider
hanger on bolt with curve away from bottom of base
as shown. Now fasten with 3/8" locknut tightly on bolt.
Repeat other 3 sides.
Complete
Step 5
Set the seat assembly over the base and fasten bottom
of glider hangers to leg assembly with (4) 2 1/2" bolts,
washers and nuts. Note: Upright base pieces are straight
up and down in front and on an angle in back.