Wilson Electronics 301135 User manual

Wall mount
Wide-Band
Panel Antenna
Wall - 50 Ohms PART# 301135
Upgrade - 50 Ohms PART# 301147
Wall - 75 Ohms PART# 301155
Wilson
®
Electronics, Inc.
The Wide-Band Panel Antenna is vertically polarized. For
optimum performance, install the antenna with the cable
running from the bottom or the top.
Antenna

1Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: [email protected] Hours: 7am to 6pm MST.
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: [email protected] Hours: 7am to 6pm MST.
Inside this Package:
Wide-Band
Panel Antenna
(301135, 301147,
301155)
In-Wall Mounting
Bracket
(901123)
Optional:
Antenna Installation Kit
Wall Mount
Wilson Signal Boosters Amplify Coverage
When used in conjunction with your antenna, a Wilson Electronics Signal Booster
can improve your cell phone and laptop data card coverage area more than 20
times. Wilson Electronics manufactures a wide range of Wireless and Direct-
Connect Signal Boosters for mobile, M2M or in-building use. See your dealer for
details or visit www.WilsonElectronics.com.
Inside Antenna Wall Installation
Find the desired location for the Panel Antenna.
Verify that the Panel Antenna and the Outside
Antenna have the necessary separation (see Signal
Booster instructions for requirements).
For optimum results, the antenna should be
mounted a minimum of 6 feet from the oor. Place
the template where the Panel Antenna is to be
installed.
Attach the template with masking tape or other
suitable adhesive tape.
Utilize Wall Mount Bracket (see Figure 1 on page
2) as your template. Drill out the four holes for
the screws in the wall, using a 3/16 size drill bit,
following your template. Install wall anchors provided
with a small hammer. Place the mounting bracket
over the wall anchors, insert the screws and tighten.
Slide the Panel Antenna onto the wall mount
bracket.
4.572 cm
1.80 in.
(Sold Separately)
Figure 1: Wall Mount
30-Day Money-Back Guarantee
All Wilson Electronics products are protected by Wilson Electronics 30-day money-back guarantee. If,
for any reason, the performance of any product is not acceptable, simply return the product directly to
the reseller with a dated proof of purchase.
90-Day Warranty
Wilson Electronics antennas are warranted for ninety (90) days against defects in workmanship and/
or materials. Warranty cases may be resolved by returning the product directly to the reseller with a
dated proof of purchase.
Antennas may also be returned directly to the manufacturer at the consumer’s expense, with a dated
proof of purchase and a Returned Material Authorization (RMA) number supplied by Wilson Electronics.
Wilson Electronics shall, at its option, either repair or replace the product. Wilson Electronics will pay for
delivery of the repaired or replaced product back to the original consumer.
This warranty does not apply to any antennas determined by Wilson Electronics to have been subjected
to misuse, abuse, neglect, or mishandling that alters or damages physical or electronic properties.
RMA numbers may be obtained by phoning Technical Support at 866-294-1660.
Disclaimer: The information provided by Wilson Electronics, Inc. is believed to be complete and
accurate. However, no responsibility is assumed by Wilson Electronics, Inc. for any business or
personal losses arising from its use, or for any infringements of patents or other rights of third parties
that may result from its use.
Copyright © 2011 Wilson Electronics, Inc. All rights reserved.

Part#104072_Rev17_102511
Wilson
®
Electronics, Inc.
Antenna Specications
Part Number 301135 301147 301155
Frequency Range
700-800 MHz / 824-894 MHz / 880-960 MHz /
1710-1880 MHz
1850-1900 MHz / 2110-2170 MHz
Impedance 50 ohms 75 ohm
Gain
5.2 dBi 700-800 MHz / 4.4 dBi 824-894 MHz /
4.2 dBi 880-960 MHz /
10.1 dBi 1710-1880 MHz / 10.6 dBi 1850-1990 MHz /
8.2 dBi 2110-2170 MHz
Polarization Vertical
Beamwidth Horizontal Plane 70 / 60 Deg
Beamwidth Vertical Plane 50 / 45 Deg
Max Power 50 watts
Connector N-Female F-Female
Dimension 8.70 x 7.00 x 1.80 (inch) / 22.098 x 17.78 x 4.572 (cm)
Weight 1.32 lbs / 0.6 kg
3301 East Deseret Drive, St. George, UT 84790
For additional Technical Support visit www.WilsonElectronics.com
or email at: [email protected]
Phone: [phone] Local: 435-673-5021 Fax: [phone]
www.twitter.com/WilsonCellular www.facebook.com/WilsonCellular