Wilson Electronics weBoost Drive Reach RV Installation guide

Drive Reach
Signal Booster
Inside Antenna
Outside
Antenna
to power
For product installation videos and more, visit:
weboost.com/install
Diagram Register your Signal Booster now!
Complete the two easy steps to register your booster and receive premium customer service,
special oers and more!
Step 1: Take a photo of your Photoregister
Code including the points ( ).
Step 2: Send it in.
Smartphone U.S. only
Text photo to 71403
Email U.S./CAN
[e-mail]
Online
register.weboost.com
OR
OR
Need help? Visit photoregister.com/help or text HELP to 71403.
weboost.com
GDE000228_Rev01_09.22.20
Installation
Overview
Drive Reach RV
Cell Signal Booster

STEP 1: Mount Outside
Antenna & Route Cable
STEP 2: Connect Cable
To Outside Antenna
STEP 5: Connect Power
Supply To Booster
STEP 4: Booster Location
& Connect Cables
STEP 3: Inside Antenna
Location
Find a location to place the Drive Reach
Booster and secure it with provided bracket.
Connect cable from Outside Antenna to
labeled booster port and connect cable from
Inside Antenna to labeled booster port.
Place Inside Antenna where stronger
signal is desired in the RV.
Determine where you want the Outside
Antenna on your RV. Mount the Outside
Antenna to a ladder or pole so that the
entire Outside Antenna is above the roof
line of the RV. Route 25’ RG-6 cable from
inside RV to Outside Antenna.
NOTE: L-Bracket Pole Mount and
hardware is provided. If installing with
Spring, the Side Exit Adapter must
be used.
Refer to Installation Guide for Detailed Instructions.
®
from Inside
Antenna
from Outside
Antenna
Booster
After routing the RG-6 Cable into the
RV, connect the cable to the
Outside Antenna.
RG-6
Cable
Inside Antenna
common Outside
Antenna mounting
location
Outside Antenna
Side Exit
Adapter
Spring
(optional)
ladder rail
L-Bracket Mount &
hardware
Connect the power supply cord to the
end of the booster, labeled “ ”, and
connect into a 110V wall plug. Enjoy your
boosted signal!