WineEnthusiast N'Finity 273 02 23 User manual

1
23 Bottle, Two Temp
Model Number: 273 02 23
PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING
AND OPERATING.
INSTRUCTION MANUAL

2
TABLE OF CONTENTS
Chapter Contents Page#
Part I. Diagram & Description of Wine Cellar 3
Part II. Important Safety & Pre-Use Instructions 4
Part III. Installation Instructions
(a) General Installation Instructions 4
(b) Installation of Built-In Unit 5
Part IV. Operating Your Wine Cellar 6
Part V. Temperature Settings 7
PartVI. Layout&Storage 7-8
Part VII. Removing the Rolling Shelf 8
PartVIII.Care&Maintenance 9
Part IX. Trouble shooting Guide 10
PartX. TechnicalInformation 11
PartXI. WarrantyInformation 11

3
PART I. DIAGRAM & DESCRIPTION OF WINE CELLAR

4
YOUR WINE CELLAR ALSO INCLUDES THE FOLLOWING:
•Instruction manual
•10 rolling shelves
•Two (2) keys
•Upper hinge
•Lower hinge
•4 screws and covers
•Hinge cover
PART II: IMPORTANT SAFETY INSTRUCTIONS
WARNING To reduce the risk of fire, electrical shock, or injury when
using your appliance, follow these basic precautions:
zRead all instructions before using the wine cellar.
zWARNING: Risk of child entrapment.
Child entrapment and suffocation are not only problems of the past. Junked or abandoned appliances are still
dangerous… even if they will “just sit in the garage for a few days”.
zBefore you throw away your old wine cellar: 1. Take off the door. 2. Leave the shelves in place so that
children may not climb inside easily.
zNever allow children to operate, play with, or crawl inside the appliance.
zNever clean appliance parts with flammable fluids. The fumes can create a fire hazard or explosion.
zDo not store in the vicinity of any other appliance. Do not store near gasoline or any other flammable vapors.
The fumes can create a fire hazard or explosion.
-Save these instructions-
BEFORE USING YOUR WINE CELLAR
zRemove the exterior and interior packing.
zBefore connecting the wine cellar to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
zClean the interior surface with lukewarm water using a soft cloth.
PART III. INSTALLATION INSTRUCTIONS
(a) General Installation Instructions
•This appliance is designed for both free standing and built-in (fully recessed) installation.
•Place your wine cellar on a flat, solid floor that is strong enough to support it when it is fully loaded. To
level your wine cellar, adjust the front leveling leg at the bottom of the wine cellar.
•When moving your wine cellar please do not incline it more than 45 degrees.

5
•Locate the wine cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit to perform improperly.
•Avoid locating the unit in damp areas.
•Plug the wine cellar into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or electrical grounding should be directed to a certified electrician or authorized products
service center.
(b) Installation of Built-in Cellar
The cutout dimension illustrated in figure (b) allows for door swing and access to the pull-out shelves when
installed as a built-in appliance.
If installing between frameless cabinets, a ½” wide filler strip or side panel may be needed on hinge side. The
filler strip will act as a spacer between the appliance case and adjacent cabinet door swing.
Figure C
The cutout depth must be 24”.

6
PART IV. OPERATING YOUR WINE CELLAR
Each wine cellar includes an operating panel on the front of the unit. This operating panel includes several features
to operate and control the temperature of both the upper and lower zones of the wine cellar. The operating panel
includes the following features:
ON/OFF: Turns the wine cellar on or off.
TEMP SET: UPPER ZONE: Adjusts and displays, via LED, the desired temperature (F) of the UPPER zone.
TEMP SET: LOWER ZONE: Adjusts and displays, via LED, the desired temperature (F) of the LOWER zone.
LIGHT: Turns the interior wine cellar light on or off.
BEFORE YOU START: The wine cellar should be placed in a location where the ambient temperature is between
45-80 degrees Fahrenheit. If the ambient temperature is above or below this range, the performance of the unit
may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures
to fluctuate.
SETTING THE TEMPERATURE CONTROL
1. Make sure power cord is connected to a properly grounded outlet.
2. Turn power ON.
3. Set the temperature of the upper or lower zone as you desire by pushing the UP (+) or DOWN (-) button.
When you push the two buttons for the first time, the LED readout will show the original temperature set at
previous time (the temperature preset at the factory is 41 °F for the upper and lower zone).
•Upper and Lower Zones: The temperature setting can be adjusted between 41°F to 64°F
4. The temperature that you desire to set will increase 1°F if you push the UP(+) button once, and alternatively
will decrease 1°F if you push the DOWN (-) button once.
5. Once you have set the desired temperature, wait 5 seconds. The temperature shown in the both Left and
Right zone display panels will automatically switch to show the actual temperature inside the unit. The actual
temperature will always be shown until the next time you press the UP(+) or DOWN (-) button to change the
temperature settings.
6. NOTE: The desired temperatures may fluctuate depending on whether the interior light is ON or OFF and
depending on the orientation of the bottles.

7
PART V. TEMPERATURE SETTINGS FOR WINE SERVICE
1. Different varietals of wine require different temperature settings. The recommended temperature ranges for
serving different varietals of wine are listed below. Your wine cellar will indicate when you have set the upper
and lower zones to the below temperature ranges.
•Red Wines: 52 - 64°F
•White Wines 44 - 51°F
•Sparkling Wines 41 - 43°F
2. If you set the upper or lower zone between 52 - 64°F, the LED light next to “RED” will light up, indicating that
you are within the recommended range for serving Red Wines.
3. If you set the upper or lower zone between 44 - 51°F, the LED light next to “WHITE” will light up, indicating that
you are within the recommended range for serving White Wines.
4. If you set the upper or lower zone between 41 - 43°F, the LED light next to “SPARKLING” will light up,
indicating that you are within the recommended range for serving Sparkling Wines
NOTE:
zIn the event of a power interruption, all previous temperature settings will be automatically saved and each
compartment will return to the previous temperature setting.
zIf the unit is unplugged, loses power, or is turned off, you must wait 3 to 5 minutes before restarting.
Attempting to restart the wine cellar before this time has elapsed may prevent the wine cellar from starting.
zWhen you use the wine cellar for the first time or restart the wine cellar after having been shut off for a long
time, there will be a few degrees variance between the temperature you select and the one indicated on the
LED readout for the first few hours of operation.After a few hours of operation, the temperature will normalize
to the displayed temperature.
DOOR LOCK
zThis unit comes with an optional key lock for each door.
zThe keys are located inside the plastic bag that contains the user manual. To unlock the door, insert the key
into the lock and turn counterclockwise.
zTo lock the door, simply reverse the operation making sure the metal pin is engaged completely. Then remove
the key and place it is a secure place for safekeeping.
PART VI. LAYOUT AND STORAGE
Your cabinet was designed to store a maximum number of bottles securely. We recommend that you observe
the tips below to optimize loading.
•Disperse your bottles evenly so as not to concentrate weight in any one area. Also, be careful that your bottles
do not touch either the back of the cabinet or the step at the bottom.
•Make sure that bottles are not all grouped together either at the top or bottom of the cabinet.
•Never try to pull out more than one sliding shelf at a time.
•Maximum capacity per shelf is 22 lbs.
•Each rolling shelf in the upper and lower zone is designed to hold one row of three bottles (see diagram on
next page).
•4 bottles per shelf, and 3 on the floor of each compartment, comprise the 23-bottle capacity. Note: when setting
bottles on the floor of the unit, Bordeaux (regular) size bottles offer the best fit.

8
PLEASE NOTE
Before modifying your cabinet’s original configuration in any way, be sure to ask your dealer for advice.
PART VII. REMOVING THE ROLLING SHELF
To remove a rolling shelf:
1. Remove all bottles
2. Pull the shelf out as far as possible
3. Push the left side lever downward while pulling right side lever upward (as illustrated below)
4. Remove the shelf

9
PART VIII. CARE AND MAINTENANCE
Cleaning Your Wine Cellar
zTurn off the power, unplug the appliance, and remove all items including all shelves.
zWash the inside surfaces with warm water and baking soda solution. The solution should be about 2 tablespoons
of baking soda with a quart of water.
zWash the shelves with a mild detergent solution.
zWring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
zWash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft
cloth.
zDust the front grill and back of the unit twice yearly. Make sure the power is off before cleaning.
zIt is recommended to clean the unit completely inside and out once a year to maximize the longevity of the wine
cellar.
Power Failure
zMost power failures are corrected within a few hours and should not affect the temperature of your appliance if you
minimize the number of times the door is opened. If the power is going to be off for a longer period of time, you
need to take the proper steps to protect your contents.
Vacation time
zShort vacations: You may leave the wine cellar operating during vacations of less than three weeks.
zLong vacations: If the appliance will not be used for several months, remove all items and turn off the appliance.
Clean and dry the interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if
necessary.
Moving Your Wine Cellar
zRemove all items.
zSecurely tape down all loose items (shelves) inside your appliance.
zTurn the adjustable leg up to the base to avoid damage.
zTape the door shut.
zBe sure the appliance stays secure in the upright position during transportation. Also protect the outside of the
appliance with a blanket or similar item.
Energy saving Tips
zThe wine cellar should be located in the coolest area of the room, away from heat producing appliances, and away
from direct sunlight.

10
PART IX. TROUBLESHOOTING GUIDE
Many common issues with your wine cellar can be solved very easily, Try the tips below to troubleshoot your wine
cellar should you experience any problems.
PROBLEM POSSIBLE CAUSE
Wine cellar does not operate. Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a fuse has blown out.
Wine cellar is not cold enough. Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket is not sealing properly.
Wine cellar is turning on and off frequently. The room temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The light does not work. Not plugged in.
The circuit breaker tripped or a fuse has blown.
The light bulb has burned out.
The light button is “OFF”.
Vibrations. Check to assure that the wine cellar is on a level surface.
The wine cellar seems to make too much noise. A faint humming noise may come from the flow of the
refrigerator, which is normal.
As each cycle ends, you may hear gurgling sounds caused
by the flow of refrigerant in your wine cellar.
Contraction and expansion of the inside walls may cause
popping and crackling noises.
The wine cellar is not on a level surface.
The door will not close properly. The wine cellar is not on a level surface.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.

11
PART X. TECHNICAL DATA
PART XI. WARRANTY INFORMATION
Please speak to your retailer before calling Wine Enthusiast if you did not purchase your wine cellar directly from Wine
Enthusiast.
Limited warranty – 90 day replacement plan with a free 9 month upgrade, totaling 1 year, on parts and labor from the
date of shipment. For customer service, please contact Wine Enthusiast by e-mail ([e-mail]) or
by phone [phone]).
The limited warranty does not cover: Damage due to such things as accident, misuse, abuse, mishandling, neglect,
unauthorized repair or any other cause beyond the control of the seller whether similar or dissimilar to the foregoing.
Purchaser understands and acknowledges that the goods sold here are wine refrigerators, which house wine.
Purchaser assumes all the risk of using these units, including risk of spoilage, humidity variations, temperature
variations, leaks, fires, water damage, mold, mildew, dryness and similar perils that may occur.
23 Bottle
Accommodation
(bottles) 23
Type of cooling compressor & air-circulated fan cooling
Climate type N
Electricity protection grade I
Nominal voltage/Frequency 110V-120V/60HZ
Rated power(W) 160W
Ambient temperature 45-80 degrees Fahrenheit
Temperature range
Upper and Lower Zone: 41F - 64F
Range of inside cabinet humidity 60%RH
item weight 93 pounds
Item dimension 15 W x 26 D X 34 5/8 H