Winmore WMHR005G2-200Y Operation and maintenance manual

INFRARED PATIO HEATER
Safety Instructions
and Operation Manual
Model: WMHR005G2-200Y

1
Thank you for purchasing our products.Please read carefully this instruction before using
and operate strictly accordance with the instructions，and especially pay attention to
"Important Safety Instructions".Please be careful collection after reading so as to for
future reference
Introduction
Your infrared heater is heating in the way of radiation (no need for medium) so your infrared
heater is effective.at the same time, the heater has very good physiotherapy effect Because it
doesn’t need to heat the ambient air (medium), it is good to be used in the open-air as well. Your
waterproof infrared patio heater offers innovative and optimal benefit with lest need of space,
perfect for heating both indoor and outdoor areas, which provides a complete new way of modern
heating technique –on the balcony, terrace, in the winter garden or generally speaking for
gastronomy and also perfectly fits as integration in big umbrella & tent systems.
Important Safety Instructions
When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, or injury to persons, etc.
Read through the operation and assembly instructions conscientiously before operating the
appliance.
Be sure to keep the manual in a safe place for future reference. If you pass the appliance on, pass
on the instructions too.
Check if the voltage indicated on the nameplate of the appliance corresponds to the local
mains voltage before you connect the appliance.
The power supply to the appliance should correspond to the relevant regulations of the power
supply companies and the regional construction regulations. Extension cords and multi-sockets
may be used only if care is exercised in their use. The marked electrical rating of the extension
cord or multi-socket should have adequate current carrying capacity and correspond to the
relevant regulations of the power supply companies and the regional construction regulations.
Check if the voltage indicated on the appliance corresponds to the marked electrical rating of
the extension cord or multi-socket before you connect the appliance.
The appliance is not located immediately below a wall socket-outlet.
Never install this appliance close to anything combustible material, such as furniture, curtains,
etc.
In order to avoid overheating and fire hazard, do not cover or obstruct the appliance. Do not
put any of the following materials on the appliance, such as clothes, blanket, pillow, paper etc.
The casing and the front cover of the appliance become extremely hot during operation. Pay
attention that, no combustible material due to Wind or other environmental influences covers
or obstructs the appliance, such as curtains, marquees, flags, plastic foil etc. Do not touch the
appliance. Caution! Risk of scald injury!
Do not let the cord hang over edge of table or counter, or touch hot surfaces.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the
appliance must be discontinued and remove the mains plug immediately. Do not try to repair

2
the appliance by your-self. Please contact with the service agent or a suitably qualified
electrician for maintenance.
Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off
before cleaning.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Keep out of reach of children. In order to keep children from the dangers of electrical
appliances, never leave them unsupervised with the machine. Consequently, when selecting
the location for your machine, do so in such a way that children do not have access to the
machine. Children being supervised not to play with the appliance.
The appliance must only be mounted by an authorized specialist, paying attention to the
relevant regulations of the power supply companies and the regional construction regulations.
WARNING: The heater must not be used if the glass panels are damaged.
–the fireguard of this heater is intended to prevent direct access to heating elements and must
be in place when the heater is in use;
–the fireguard does not give full protection for young children and for infirm persons.
Please unplug the appliance when not use.
The appliance shall not be used in building sites.
WARNING: This heater is not equipped with a device to control the room temperature.
Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
The heater is to be installed so that switches and other controls cannot be touched by a
person in the bath or shower.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance
provided that it has been placed or installed in its intended normal operating position
and they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
CAUTION —Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.
Save These Instructions
Specifications
Model
□WMHR005G2-200Y
Voltage (V)
□ 220-240V～, 50Hz

3
Power consumption (W)
□2000W
Dimensions
W×H×D (cm)
□630.0×100.0×77.0
Weight (kg)
□2.5
IP protection
IP65
Infrared receiving Angle
□ 60°±5°
The control distance(M)
□ 6
Battery type
□ AAA size1.5V ,2 pieces
Switch
□ ON/OFF
Remote Control Instructions
Button
Graphic
Function
Feature
Low
Low step
1.50﹪power output；
2.Receiver light in heater is Blue
Med
Medium
step
1.75﹪power output；
2.Receiver light in heater is Purple。
High
High step
1.100﹪power output；
2.Receiver light in heater is Red。
On
On
1.Turn on the heater；
2.Receiver light in heater will first turn Blue with
33﹪power output..The receiver light will
change to red with full output.after 4 seconds .
Off
Off
1.Turn off the heater；
2.The receiver light will be flash in blue color if
the heater connects to the power supply.there
will be no indication after cutting off the
electricity.
The normal control distance
Maximum receiving angle

4
m 6m
Notice：
Use 2 pieces AAA size1.5V batteries in the remote control.Remove the battery when not use for
long time,thus the lifespan of remote control can be extended.
Choose the same specification battery when replacing the battery inside,otherwise it may cause
remote control not work ,thereby affect the normal use of the heater.
Please contact service agent for further help if you need the function.
The remote control function may be out of work if there is a barrier between the remote control
and heater .
Replacing the batteries duly so as not to affect the normal use of heater and remote control.
Operation Instruction
For additional protection the installation of a residual current device (RCD) is advisable.
Remove all package material (including anti-vibration object of the lamp) and check the
appliance, supply cord and the plug for signs of damage.
Pay attention to the mounting place and all mounting material(dowels, screws). Ensure they
are suitable and stable enough for mounting and lastingly holding of the appliance.
Before mounting, the minimum safe mounting distances and tilt angles shown in the figures
must be strictly followed.
1. The distance between the bottom edge of the appliance and the floor must be at least
1.8 M.
2. There must be a distance of at least 0.2 M between the appliance and the ceilings, roofs
or other covers.
3. There must be a distance of at least 0.5 M at each side between the appliance and walls
or the like. See figure 2.
4. Remember that degree to mounting surface is 45°.
Pay attention that, the installation of the appliance must not add excessive wind load.
Fix the mounting bracket on the wall first. Ensure that the place to be installed is secure and
firm. Or connect the appliance to the stand.
The heaters are also widely used under parasol with the help of parasol brackets
Adjust the desired angle of radiation and fest screw all screws. Check regularly the screws’
connection. Mechanical bearing pressure and oscillation due to wind or rain could lead to loose.
Plug in the power source. Then observe, whether during the first 10-15 minutes the appliance
works trouble-free.
Remote
Control
Heater

5
Figure 1: Mounting bracket (wall bracket) and anchor dowels provided. Connection
from the wall to the infrared heater.
Figure 2 Min. distance to floor, ceiling
and wall
Figure 3 3: Tilt angle
Cleaning and Maintenance
This appliance is consist of a robust and maintenance-free aluminum casing with a protection
cover. No user serviceable parts inside.
Before cleaning, remove the plug from the power outlet and wait until the appliance is
sufficiently cooled off.
Wipe the appliance only with clean and lint-free cloth or a soft brush.
Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!

6
The alcohol can be used to clean the appliance. When cleaning the reflector, please contact
with the service agent or a suitably qualified electrician if the reflector needs to be removed
To protect against electrical shock and danger of life, do not immerse cord, plug, or any part of
the appliance in water or other liquid.
For heating element replacement, please contact the manufacturer or its service agent or a
similarly qualified person.
Storage
Do not route cord when heater storage, or heater is not in use.
Disposal
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Customer Service
Repairs must be carried out by authorized specialists, thus ensuring electrical safety. Please contact
with the service agent or a suitably qualified electrician.
Improper repairs could lead to danger to the user.
This warranty does not cover damage of failure which results from alteration, accident, misuse,
abuse, neglect, commercial use or improper maintenance.
In line with our policy of continuous product development we reserve the right to change the
product and documentation specifications without notice.