4
Operating your WiTi Motorhome Alarm System
The WiTi Motorhome Alarm System is Australia’s leading Alarm and
Intrusion Detection System designed for motorhomes.
In the event an attempt is made to break into the vehicle the Alarm
system will be activated. All the lights flash and the alarm sounds. This
continues as long as movement is detected. Once movement ceases
WiTi Motorhome Alarm will reset aer 30 seconds. WiTi Motorhome
Alarm is sensitive to high frequency impacts (metal on metal). A
sideways / rocking motion has been programmed out to prevent
activation in windy conditions.
WiTi Motorhome Alarm includes a Passive Infra Red Motion Sensor and
a Magnetic Door Switch. If the door is opened or movement is detected
within the vehicle then the system will be activated. The Motion Sensor
can be switched on/o via the switch on the side of the Motion Sensor
Unit. By switching o the Motion Sensor the alarm can be activated
while moving around inside the motorhome.
To activate WiTi Motorhome Alarm, press button A
on the remote control, the side and front markers
and indicators will flash once followed by a 3
second safety pause and then a double flash to
indicate the system is armed. The Alarm Status LED
will illuminate. To deactivate, press button A again,
the side and front markers and indicators will flash
once and the Alarm Status LED will switch o.
Button B on the remote control activates an
emergency Panic Alarm. To activate the Panic
Alarm, press and hold Button B for 3 seconds. To
deactivate press and release button B again.
WiTi incorporates an advanced safety system to ensure the system
cannot be accidentally activated whilst the vehicle is moving. Aer
activating the system, if movement is detected during the 3 second
safety pause the system will not arm. The lights will not flash twice and
the Alarm Status LED will not illuminate.
Button A
Arm/Disarm
Button B
Panic
